计量学报
計量學報
계량학보
ACTA METROLOGICA SINICA
2010年
1期
5-8
,共4页
廖昌荣%何国田%骆静%刘会兵%李兴
廖昌榮%何國田%駱靜%劉會兵%李興
료창영%하국전%락정%류회병%리흥
计量学%磁流变液%磁流变脂%流变特性%检测方法
計量學%磁流變液%磁流變脂%流變特性%檢測方法
계량학%자류변액%자류변지%류변특성%검측방법
Metrology%Magnnetorheological(MR) fluids%MR grease%Rheological Behaviors%Test methodology
针对现有测试装置剪切率低且难以使磁流变脂达到磁饱和的问题,提出了一种基于同心圆筒双边剪切模式的磁流变脂流变学特性检测方法,分析了剪切通道中磁流变脂在转子作用下的剪切流动特性与剪切应力分布,建立了磁流变脂传递力矩与剪切应力的理论关系,得出了由传递力矩导出标称剪切应力的近似算法;通过建立剪切率与剪切应力之间的函数关系,利用剪切通道中磁流变脂的平衡微分方程和流动边界条件,得出了由转子角速度导出磁流变脂标称剪切率近似算法;通过实验方法研究了剪切通道平均磁通密度与励磁电流的关系;设计与制作了磁流变脂检测装置,并利用磁流变脂检测装置完成了某典型磁流变脂检测,使磁流变脂的剪切率达到2000s~(-1)、磁通密度超过0.6T,测试结果与其它检测装置检测结果能较好吻合.
針對現有測試裝置剪切率低且難以使磁流變脂達到磁飽和的問題,提齣瞭一種基于同心圓筒雙邊剪切模式的磁流變脂流變學特性檢測方法,分析瞭剪切通道中磁流變脂在轉子作用下的剪切流動特性與剪切應力分佈,建立瞭磁流變脂傳遞力矩與剪切應力的理論關繫,得齣瞭由傳遞力矩導齣標稱剪切應力的近似算法;通過建立剪切率與剪切應力之間的函數關繫,利用剪切通道中磁流變脂的平衡微分方程和流動邊界條件,得齣瞭由轉子角速度導齣磁流變脂標稱剪切率近似算法;通過實驗方法研究瞭剪切通道平均磁通密度與勵磁電流的關繫;設計與製作瞭磁流變脂檢測裝置,併利用磁流變脂檢測裝置完成瞭某典型磁流變脂檢測,使磁流變脂的剪切率達到2000s~(-1)、磁通密度超過0.6T,測試結果與其它檢測裝置檢測結果能較好吻閤.
침대현유측시장치전절솔저차난이사자류변지체도자포화적문제,제출료일충기우동심원통쌍변전절모식적자류변지류변학특성검측방법,분석료전절통도중자류변지재전자작용하적전절류동특성여전절응력분포,건립료자류변지전체력구여전절응력적이론관계,득출료유전체력구도출표칭전절응력적근사산법;통과건립전절솔여전절응력지간적함수관계,이용전절통도중자류변지적평형미분방정화류동변계조건,득출료유전자각속도도출자류변지표칭전절솔근사산법;통과실험방법연구료전절통도평균자통밀도여려자전류적관계;설계여제작료자류변지검측장치,병이용자류변지검측장치완성료모전형자류변지검측,사자류변지적전절솔체도2000s~(-1)、자통밀도초과0.6T,측시결과여기타검측장치검측결과능교호문합.
A test method for rheological behaviors of MR greases based on double rotational coaxial cylinder shear mode is presented to obtain high shear strain rate and magnetic flux density. Both flow velocity profiles and shear stress profiles of MR greases in shear channels are analyzed. The theory relationship between shear stress acted on MR greases and transmission torques is established, the approximate algorithm is put forwarded to acquire nominal shear stresses of MR greases via transmission torques parameters. The relationship between shear strain rate and shear stresses is comprehensively established. On the basis of differential equation and its rational boundary conditions from stress equilibrium of MR greases micro-unit, the approximate algorithm is developed for nominal shear strain rates via rotor angular velocities. The relationship between average value of magnetic flux density in annular channels and excitation electrical currents are experimentally obtained. Based on the test method above, a rheometer is fabricated and modulated in Chongqing University, in which, torque sensor, angular velocity sensor and amperemeter are respectively used to test transmission torque, angular velocity and electrical current. Rheological parameters of certain MR grease by the rheometer, whose shear rate is more than 2000s~(-1) and magnetic flux density acting on MR greases exceed 0.6T, are in good agreement with those from the test with commercial rheometers.