临床口腔医学杂志
臨床口腔醫學雜誌
림상구강의학잡지
JOURNAL OF CLINICAL STOMATOLOGY
2004年
3期
134-137
,共4页
郭宏%刘洪臣%张润荃%高勇%王延荣
郭宏%劉洪臣%張潤荃%高勇%王延榮
곽굉%류홍신%장윤전%고용%왕연영
颞下颌关节%有限元法%应力分析%计算机模拟
顳下頜關節%有限元法%應力分析%計算機模擬
섭하합관절%유한원법%응력분석%계산궤모의
目的:探讨正常人牙尖交错位紧咬牙时颞下颌关节内的应力分布情况,了解生理状况下TMJ生物力学特点.方法:应用ANSYS 6.1对以往研究所建正常颞下颌关节三维有限元模型进行分析.加载情况接近正常生事.由ANSYS 6.1进行求解.在后处理器中研究分析应力分布与形变.结果:正常人牙尖交错位紧咬牙时颞下颌关节内拉压应力并存,存在剪切应力,分布较均匀,无特别明显应力集中表现.髁突前斜面等效应力值高于后斜面,而前斜面外侧区的应力值又明显高于内侧、中间区;髁突表面剪切应力较高的区域位于外侧区前斜面,靠近髁突嵴顶.关节盘腹面平均应力值大于背面,且背面应力分布较腹面均匀.腹面应力分布,外侧区最高,最大应力值0.244位于后带与双板区交界处;后带与中间带差别不大,但都明显大于前带.关节盘的变形量明显大于髁突及颞骨关节窝.颞骨关节窝前部即关节结节后斜面等效应力较大.结论:正常牙尖交错位紧咬牙时颞下颌关节内的应力分布,与髁突、关节盘、颞骨关节窝的解剖生理之间,具有良好的功能适应性.
目的:探討正常人牙尖交錯位緊咬牙時顳下頜關節內的應力分佈情況,瞭解生理狀況下TMJ生物力學特點.方法:應用ANSYS 6.1對以往研究所建正常顳下頜關節三維有限元模型進行分析.加載情況接近正常生事.由ANSYS 6.1進行求解.在後處理器中研究分析應力分佈與形變.結果:正常人牙尖交錯位緊咬牙時顳下頜關節內拉壓應力併存,存在剪切應力,分佈較均勻,無特彆明顯應力集中錶現.髁突前斜麵等效應力值高于後斜麵,而前斜麵外側區的應力值又明顯高于內側、中間區;髁突錶麵剪切應力較高的區域位于外側區前斜麵,靠近髁突嵴頂.關節盤腹麵平均應力值大于揹麵,且揹麵應力分佈較腹麵均勻.腹麵應力分佈,外側區最高,最大應力值0.244位于後帶與雙闆區交界處;後帶與中間帶差彆不大,但都明顯大于前帶.關節盤的變形量明顯大于髁突及顳骨關節窩.顳骨關節窩前部即關節結節後斜麵等效應力較大.結論:正常牙尖交錯位緊咬牙時顳下頜關節內的應力分佈,與髁突、關節盤、顳骨關節窩的解剖生理之間,具有良好的功能適應性.
목적:탐토정상인아첨교착위긴교아시섭하합관절내적응력분포정황,료해생리상황하TMJ생물역학특점.방법:응용ANSYS 6.1대이왕연구소건정상섭하합관절삼유유한원모형진행분석.가재정황접근정상생사.유ANSYS 6.1진행구해.재후처리기중연구분석응력분포여형변.결과:정상인아첨교착위긴교아시섭하합관절내랍압응력병존,존재전절응력,분포교균균,무특별명현응력집중표현.과돌전사면등효응력치고우후사면,이전사면외측구적응력치우명현고우내측、중간구;과돌표면전절응력교고적구역위우외측구전사면,고근과돌척정.관절반복면평균응력치대우배면,차배면응력분포교복면균균.복면응력분포,외측구최고,최대응력치0.244위우후대여쌍판구교계처;후대여중간대차별불대,단도명현대우전대.관절반적변형량명현대우과돌급섭골관절와.섭골관절와전부즉관절결절후사면등효응력교대.결론:정상아첨교착위긴교아시섭하합관절내적응력분포,여과돌、관절반、섭골관절와적해부생리지간,구유량호적공능괄응성.