四川大学学报(自然科学版)
四川大學學報(自然科學版)
사천대학학보(자연과학판)
JOURNAL OF SICHUAN UNIVERSITY(NATURAL SCIENCE EDITION)
2010年
2期
327-330
,共4页
喻菁%邓爱红%余鑫祥%龙娟娟%周宇璐%陈燕
喻菁%鄧愛紅%餘鑫祥%龍娟娟%週宇璐%陳燕
유정%산애홍%여흠상%룡연연%주우로%진연
磁控溅射%纳米晶钛膜%X射线衍射(XRD)%晶粒尺寸
磁控濺射%納米晶鈦膜%X射線衍射(XRD)%晶粒呎吋
자공천사%납미정태막%X사선연사(XRD)%정립척촌
magnetron sputtering%nanocrystalline titanium film%X-ray diffraction%grain size
本文采用直流磁控溅射方法,在He/Ar混合气氛中,通过分别改变He/Ar流量比和沉积偏压制备不同He含量的钛膜.利用XRD(X-ray diffraction)对含He钛膜的微观结构和晶粒尺寸进行了研究.结果表明,在其它实验参数不变的情况下,当He/Ar流量比从1.0增加到25时,钛膜的平均晶粒尺寸从19.02 nm减小到8.63 nm.随着膜中He含量的增加,衍射峰宽化,晶粒细化,He的掺入有抑制纳米晶粒长大的趋势.而当沉积偏压从24 V增加到151 V时,其平均晶粒尺寸基本不变.He引入引起了(002)晶面衍射峰向小角度移动,晶格参数c增加,而a不变.
本文採用直流磁控濺射方法,在He/Ar混閤氣氛中,通過分彆改變He/Ar流量比和沉積偏壓製備不同He含量的鈦膜.利用XRD(X-ray diffraction)對含He鈦膜的微觀結構和晶粒呎吋進行瞭研究.結果錶明,在其它實驗參數不變的情況下,噹He/Ar流量比從1.0增加到25時,鈦膜的平均晶粒呎吋從19.02 nm減小到8.63 nm.隨著膜中He含量的增加,衍射峰寬化,晶粒細化,He的摻入有抑製納米晶粒長大的趨勢.而噹沉積偏壓從24 V增加到151 V時,其平均晶粒呎吋基本不變.He引入引起瞭(002)晶麵衍射峰嚮小角度移動,晶格參數c增加,而a不變.
본문채용직류자공천사방법,재He/Ar혼합기분중,통과분별개변He/Ar류량비화침적편압제비불동He함량적태막.이용XRD(X-ray diffraction)대함He태막적미관결구화정립척촌진행료연구.결과표명,재기타실험삼수불변적정황하,당He/Ar류량비종1.0증가도25시,태막적평균정립척촌종19.02 nm감소도8.63 nm.수착막중He함량적증가,연사봉관화,정립세화,He적참입유억제납미정립장대적추세.이당침적편압종24 V증가도151 V시,기평균정립척촌기본불변.He인입인기료(002)정면연사봉향소각도이동,정격삼수c증가,이a불변.
Helium-charged titanium films was prepared at different flux ratio of He/Ar, different substrate bias voltage by magnetron sputtering in a gas mixture of helium and argon. The microstructure and average grain size of the nanocrystalline titanium films was investigated by XRD(X- ray diffraction). The results indicated that under the same deposition parameters except the flux ratio of He/Ar ,with increased from 1.0 to 25, the grain size decreased from 19.02 nm to 8.63 nm.When increasing helium content in the film, the diffraction peaks broadened and grain sizes decreased. These results further indicated that the incorporation of helium has a tendency to suppress the gain growth of film. When substrate bias voltage increased from 24 V to 151 V,the grain size nearly invariability. The Bragg peak of (002) crystal plane in the film had a slight shift to of the left comparing with that of the pure Ti film. This indicated that the lattice parameter c increased but the lattice parameter a remained the same.