棉纺织技术
棉紡織技術
면방직기술
COTTON TEXTILE TECHNOLOGY
2009年
8期
59-60
,共2页
喷气织机%缎条织物%穿筘方法%穿综方法%开口时间%上机张力%引纬工艺
噴氣織機%緞條織物%穿筘方法%穿綜方法%開口時間%上機張力%引緯工藝
분기직궤%단조직물%천구방법%천종방법%개구시간%상궤장력%인위공예
Air-jet Loom%Satin Stripped Fabric%Reed-in Method%Draft Lifting Plan%Shed Timing%Loom Tension%Weft Insertion Processing
探讨在omniplus-190型喷气织机上生产特细号高密缎条织物的工艺调整方法.针对该品种总经根数多、织机效率低、布面质量差的问题,经过试验摸索,认为在穿筘工序采用每筘4入,在穿综工序地组织采用飞穿法、边组织采用纬重平穿法,在织造工序合理设定开口角、综框高度、开口时间、后梁、停经架、上机张力、引纬工艺等参数,可使织机效率由60%左右上升到85%左右,下机一等品率达98%.
探討在omniplus-190型噴氣織機上生產特細號高密緞條織物的工藝調整方法.針對該品種總經根數多、織機效率低、佈麵質量差的問題,經過試驗摸索,認為在穿筘工序採用每筘4入,在穿綜工序地組織採用飛穿法、邊組織採用緯重平穿法,在織造工序閤理設定開口角、綜框高度、開口時間、後樑、停經架、上機張力、引緯工藝等參數,可使織機效率由60%左右上升到85%左右,下機一等品率達98%.
탐토재omniplus-190형분기직궤상생산특세호고밀단조직물적공예조정방법.침대해품충총경근수다、직궤효솔저、포면질량차적문제,경과시험모색,인위재천구공서채용매구4입,재천종공서지조직채용비천법、변조직채용위중평천법,재직조공서합리설정개구각、종광고도、개구시간、후량、정경가、상궤장력、인위공예등삼수,가사직궤효솔유60%좌우상승도85%좌우,하궤일등품솔체98%.
Processing adjustment method of producing super fine high density satin stripped fabric in Omniplus-190 air-jet loom was discussed. According to the problems such as total warp number is larger,loom efficiency is lower and fabric surface is worse, through test and experiences, it is considered that 4 warp per reed was adopted in reed-in process, intermittent draw was adopted to ground weave and weft rib weave draw was adopted to edge weave in draft lifting plan process. In weaving process opening angle,heald frame height, shed time,back beam, stop frame,loom tension,weft insertion processing et al should be set properly,loom efficiency could be improve from 60% to 85% ,first grade percent-age before cloth repairing could reach 98%.
