中国水产科学
中國水產科學
중국수산과학
Journal of Fishery Sciences of China
2012年
5期
889-899
,共11页
赵云鹏%陈小芳%许条建%关长涛%崔勇
趙雲鵬%陳小芳%許條建%關長濤%崔勇
조운붕%진소방%허조건%관장도%최용
重力式网箱%物理模型试验%水动力特性%数值模拟
重力式網箱%物理模型試驗%水動力特性%數值模擬
중력식망상%물리모형시험%수동력특성%수치모의
针对鲆鲽类方形重力式网箱在纯波浪条件下的水动力特性,采用数值模拟的方法对鲆鲽类方形深水重力式网箱的主要部件——浮架系统、配重系统、锚碇系统进行了模拟.将模拟结果与实验结果进行分析比较表明,数模与物模各量值吻合良好,平均相对误差均不超过9%,表明数值模拟的方法能较好地模拟鲆鲽类方形深水重力式网箱的水动力特性.在此基础上,用数值模拟的方法,进一步研究了底框质量和网衣高度的改变对网箱各参数的影响,模拟结果显示,底框质量改变主要影响锚绳受力和底框倾角,底框质量从80 g升至100 g再升至140 g的过程中,锚绳受力平均增幅分别为13%和19%,同时增大底框质量有助于减小底框运动倾角,其平均降幅分别为8.8%和9.3%;网衣高度由20 cm增至30 cm后,锚绳受力平均增加15%,同时网衣的增高导致对浮架和底框的牵制作用加大,使得浮架和底框的运动幅度有所减小,降幅不超过10%.在以上研究结果的基础上,为鲆鲽类网箱的设计与优化提供了参考建议.
針對鲆鰈類方形重力式網箱在純波浪條件下的水動力特性,採用數值模擬的方法對鲆鰈類方形深水重力式網箱的主要部件——浮架繫統、配重繫統、錨碇繫統進行瞭模擬.將模擬結果與實驗結果進行分析比較錶明,數模與物模各量值吻閤良好,平均相對誤差均不超過9%,錶明數值模擬的方法能較好地模擬鲆鰈類方形深水重力式網箱的水動力特性.在此基礎上,用數值模擬的方法,進一步研究瞭底框質量和網衣高度的改變對網箱各參數的影響,模擬結果顯示,底框質量改變主要影響錨繩受力和底框傾角,底框質量從80 g升至100 g再升至140 g的過程中,錨繩受力平均增幅分彆為13%和19%,同時增大底框質量有助于減小底框運動傾角,其平均降幅分彆為8.8%和9.3%;網衣高度由20 cm增至30 cm後,錨繩受力平均增加15%,同時網衣的增高導緻對浮架和底框的牽製作用加大,使得浮架和底框的運動幅度有所減小,降幅不超過10%.在以上研究結果的基礎上,為鲆鰈類網箱的設計與優化提供瞭參攷建議.
침대평접류방형중력식망상재순파랑조건하적수동력특성,채용수치모의적방법대평접류방형심수중력식망상적주요부건——부가계통、배중계통、묘정계통진행료모의.장모의결과여실험결과진행분석비교표명,수모여물모각량치문합량호,평균상대오차균불초과9%,표명수치모의적방법능교호지모의평접류방형심수중력식망상적수동력특성.재차기출상,용수치모의적방법,진일보연구료저광질량화망의고도적개변대망상각삼수적영향,모의결과현시,저광질량개변주요영향묘승수력화저광경각,저광질량종80 g승지100 g재승지140 g적과정중,묘승수력평균증폭분별위13%화19%,동시증대저광질량유조우감소저광운동경각,기평균강폭분별위8.8%화9.3%;망의고도유20 cm증지30 cm후,묘승수력평균증가15%,동시망의적증고도치대부가화저광적견제작용가대,사득부가화저광적운동폭도유소감소,강폭불초과10%.재이상연구결과적기출상,위평접류망상적설계여우화제공료삼고건의.