精密成形工程
精密成形工程
정밀성형공정
METAL FORMING TECHNOLOGY
2011年
6期
33-36
,共4页
李洪洋%陈成%李先超%张妍婧
李洪洋%陳成%李先超%張妍婧
리홍양%진성%리선초%장연청
钛合金%Hopkinson压杆%强迫剪切%动态应变
鈦閤金%Hopkinson壓桿%彊迫剪切%動態應變
태합금%Hopkinson압간%강박전절%동태응변
titanium alloy%SHPB%forced shear%dynamic deformation
以10mm厚度的热轧钛合金板TC4为原料,通过Hopkinson压杆实验和强迫剪切实验,对高应变率下的厚板钛合金的塑性行为进行了研究和分析,得到了不同热处理制度下材料的真实应力-应变曲线,并观察了不同热处理制度下试验后材料的微观组织。
以10mm厚度的熱軋鈦閤金闆TC4為原料,通過Hopkinson壓桿實驗和彊迫剪切實驗,對高應變率下的厚闆鈦閤金的塑性行為進行瞭研究和分析,得到瞭不同熱處理製度下材料的真實應力-應變麯線,併觀察瞭不同熱處理製度下試驗後材料的微觀組織。
이10mm후도적열알태합금판TC4위원료,통과Hopkinson압간실험화강박전절실험,대고응변솔하적후판태합금적소성행위진행료연구화분석,득도료불동열처리제도하재료적진실응력-응변곡선,병관찰료불동열처리제도하시험후재료적미관조직。
The TC4 of hot rolling titanium alloy sheet of 10 mm thickness was taken as the raw material in this paper. The plastic behavior of titanium alloy sheet at the high strain rate was studied and analyzed through the Hopkinson compressive bar and forced shear experiments. The material true stress strain curves of different heat treatment mechanisms were obtained. At last the microstructures of tested materials with different heat treatment mechanisms were also observed.