稀有金属
稀有金屬
희유금속
CHINESE JOURNAL OF RARE METALS
2012年
4期
676-680
,共5页
王克勤%宋嘉伟%高燕%姜武
王剋勤%宋嘉偉%高燕%薑武
왕극근%송가위%고연%강무
拜耳法赤泥%浸出%液固比
拜耳法赤泥%浸齣%液固比
배이법적니%침출%액고비
在用盐酸浸出氧化铝赤泥提取氧化钪的过程中,稀土元素镧,铈,钕也一同浸出,进入到浸出液中.研究了拜耳法赤泥盐酸浸出稀土元素镧,铈,钕的过程.研究了浸出温度、酸度、液固比和浸出时间对稀土元素浸出率的影响.研究结果表明,影响稀土浸出率的因素依次是浸出温度,盐酸浓度,配料液固比,和浸出时间.当接近沸点109℃浸出时,镧、铈、钕浸出率提高最快.盐酸酸度在4~5 mol·L-1时,浸出率升高较快,5~7 mol·L-1时,缓慢提高,当超过7 mol·L-1时,镧、铈、钕的浸出率基本不变化.当液固比为4.0时,镧、铈、钕元素的浸出率较低,仅为60%~75%之间,当液固比提高到5.0时,稀土元素的浸出率升高较快.随着浸出时间的延长,氧化稀土的浸出率从60~180 min时,缓慢提高,在180 min时达到最大值,超过180 min后,变化不大.在温度为沸点(109℃),液固比6.0,时间180 min.盐酸浓度7 mol·L-1的条件下浸出,赤泥中La,Ce,Nd的浸出率能达到95%以上.
在用鹽痠浸齣氧化鋁赤泥提取氧化鈧的過程中,稀土元素鑭,鈰,釹也一同浸齣,進入到浸齣液中.研究瞭拜耳法赤泥鹽痠浸齣稀土元素鑭,鈰,釹的過程.研究瞭浸齣溫度、痠度、液固比和浸齣時間對稀土元素浸齣率的影響.研究結果錶明,影響稀土浸齣率的因素依次是浸齣溫度,鹽痠濃度,配料液固比,和浸齣時間.噹接近沸點109℃浸齣時,鑭、鈰、釹浸齣率提高最快.鹽痠痠度在4~5 mol·L-1時,浸齣率升高較快,5~7 mol·L-1時,緩慢提高,噹超過7 mol·L-1時,鑭、鈰、釹的浸齣率基本不變化.噹液固比為4.0時,鑭、鈰、釹元素的浸齣率較低,僅為60%~75%之間,噹液固比提高到5.0時,稀土元素的浸齣率升高較快.隨著浸齣時間的延長,氧化稀土的浸齣率從60~180 min時,緩慢提高,在180 min時達到最大值,超過180 min後,變化不大.在溫度為沸點(109℃),液固比6.0,時間180 min.鹽痠濃度7 mol·L-1的條件下浸齣,赤泥中La,Ce,Nd的浸齣率能達到95%以上.
재용염산침출양화려적니제취양화항적과정중,희토원소란,시,녀야일동침출,진입도침출액중.연구료배이법적니염산침출희토원소란,시,녀적과정.연구료침출온도、산도、액고비화침출시간대희토원소침출솔적영향.연구결과표명,영향희토침출솔적인소의차시침출온도,염산농도,배료액고비,화침출시간.당접근비점109℃침출시,란、시、녀침출솔제고최쾌.염산산도재4~5 mol·L-1시,침출솔승고교쾌,5~7 mol·L-1시,완만제고,당초과7 mol·L-1시,란、시、녀적침출솔기본불변화.당액고비위4.0시,란、시、녀원소적침출솔교저,부위60%~75%지간,당액고비제고도5.0시,희토원소적침출솔승고교쾌.수착침출시간적연장,양화희토적침출솔종60~180 min시,완만제고,재180 min시체도최대치,초과180 min후,변화불대.재온도위비점(109℃),액고비6.0,시간180 min.염산농도7 mol·L-1적조건하침출,적니중La,Ce,Nd적침출솔능체도95%이상.