宇航学报
宇航學報
우항학보
JOURNAL OF ASTRONAUTICS
2010年
2期
608-614
,共7页
刘守文%尹晓芳%裴一飞%孙来燕
劉守文%尹曉芳%裴一飛%孫來燕
류수문%윤효방%배일비%손래연
蒙特卡罗方法%红外灯%辐射%热流分布
矇特卡囉方法%紅外燈%輻射%熱流分佈
몽특잡라방법%홍외등%복사%열류분포
Monte carlo method%Infrared lamp%Radiation%Heat flux distribution
采用蒙特卡罗方法针对我国航天器热平衡试验用红外灯的热流分布进行了研究.对红外灯能束辐射过程的物理模型进行了分析,建立了能束辐射随机位置、随机方向的数学模型和灯丝温度计算模型,给出了辐射波长、灯管反射率、吸收率、透射率的确定方法,进而提出了红外灯热流分布计算流程.在真空低温环境下进行了红外灯热流分布测试,将预测结果与试验结果进行了对比,偏差在5%以内.采用本文的分析方法计算了某型号卫星试验用红外灯阵的热流分布,结果满足试验要求.该方法可以作为红外灯阵优化设计的技术基础.
採用矇特卡囉方法針對我國航天器熱平衡試驗用紅外燈的熱流分佈進行瞭研究.對紅外燈能束輻射過程的物理模型進行瞭分析,建立瞭能束輻射隨機位置、隨機方嚮的數學模型和燈絲溫度計算模型,給齣瞭輻射波長、燈管反射率、吸收率、透射率的確定方法,進而提齣瞭紅外燈熱流分佈計算流程.在真空低溫環境下進行瞭紅外燈熱流分佈測試,將預測結果與試驗結果進行瞭對比,偏差在5%以內.採用本文的分析方法計算瞭某型號衛星試驗用紅外燈陣的熱流分佈,結果滿足試驗要求.該方法可以作為紅外燈陣優化設計的技術基礎.
채용몽특잡라방법침대아국항천기열평형시험용홍외등적열류분포진행료연구.대홍외등능속복사과정적물리모형진행료분석,건립료능속복사수궤위치、수궤방향적수학모형화등사온도계산모형,급출료복사파장、등관반사솔、흡수솔、투사솔적학정방법,진이제출료홍외등열류분포계산류정.재진공저온배경하진행료홍외등열류분포측시,장예측결과여시험결과진행료대비,편차재5%이내.채용본문적분석방법계산료모형호위성시험용홍외등진적열류분포,결과만족시험요구.해방법가이작위홍외등진우화설계적기술기출.
The Monte Carlo method is employed to establish the heat flux distribution of the infrared lamp used in thermal vacuum test of spacecraft. The physical model of a ray from infrared lamp is depicted. The mathematical model is established to obtain the random location and direction of ray and the filament temperature. The analysis methods for radiation wavelength are introduced. The reflectivity, absorptivity and transmissivity of quartz envelope are investigated. Finally, infrared lamp heat flux distribution computing processes was built up. The heat flux distribution of infrared lamp is tested under low temperature and vacuum environment. Comparing the computed result with the experimental data shows a deviation less than 5%. The analysis method is successfully used to calculate the heat flux distribution of infrared lamp array in a satellite ground test. The method in this paper can apply as technological base for infrared lamp array optimization design.