强激光与粒子束
彊激光與粒子束
강격광여입자속
HIGH POWER LASER AND PARTICLEBEAMS
2010年
4期
701-704
,共4页
王庆峰%刘庆想%张政权%徐远灿%胡克松
王慶峰%劉慶想%張政權%徐遠燦%鬍剋鬆
왕경봉%류경상%장정권%서원찬%호극송
抖动%脉冲前沿%直线变压器驱动源%同步工作
抖動%脈遲前沿%直線變壓器驅動源%同步工作
두동%맥충전연%직선변압기구동원%동보공작
jitter%rise time%linear transformer driver%synchronous work
以正态分布作为开关延时的数学模型,讨论了多路开关同步工作时,开关抖动、单路输出波形前沿对直线变压器驱动源多路波形叠加的影响.模拟研究结果表明:开关抖动对输出波形前沿的影响与单路输出波形的质量有关,单路波形前沿越小,开关抖动对感应叠加后输出波形前沿影响越明显.考虑4路同步工作的开关抖动为5 ns,单路波形前沿由10 ns增大到80 ns,感应叠加后输出波形前沿平均增量由6.7 ns减小为1.7 ns,因此当单路输出波形前沿较大时追求开关抖动小的意义不大.
以正態分佈作為開關延時的數學模型,討論瞭多路開關同步工作時,開關抖動、單路輸齣波形前沿對直線變壓器驅動源多路波形疊加的影響.模擬研究結果錶明:開關抖動對輸齣波形前沿的影響與單路輸齣波形的質量有關,單路波形前沿越小,開關抖動對感應疊加後輸齣波形前沿影響越明顯.攷慮4路同步工作的開關抖動為5 ns,單路波形前沿由10 ns增大到80 ns,感應疊加後輸齣波形前沿平均增量由6.7 ns減小為1.7 ns,因此噹單路輸齣波形前沿較大時追求開關抖動小的意義不大.
이정태분포작위개관연시적수학모형,토론료다로개관동보공작시,개관두동、단로수출파형전연대직선변압기구동원다로파형첩가적영향.모의연구결과표명:개관두동대수출파형전연적영향여단로수출파형적질량유관,단로파형전연월소,개관두동대감응첩가후수출파형전연영향월명현.고필4로동보공작적개관두동위5 ns,단로파형전연유10 ns증대도80 ns,감응첩가후수출파형전연평균증량유6.7 ns감소위1.7 ns,인차당단로수출파형전연교대시추구개관두동소적의의불대.
For switch delay of normal distribution, the effects of switch jitter and single waveform's rise time on the rise time of resultant waveforms are discussed when multiple switches work synchronously. The simulation result shows that the effects of switch jitter on the rise time of resultant waveforms are related to the single waveform's rise time. The less the rise time of single waveform is, the stronger the effects of switch jitter on the rise time of resultant waveforms. For four switches with the jitter of 5 ns, the rise time of resultant waveforms will decrease from 6.7 ns to 1.7 ns when the rise time of single waveform increases from 10 ns to 80 ns. When the rise time of single waveform is large, there is no use going for small switch jitter.