防灾减灾工程学报
防災減災工程學報
방재감재공정학보
JOURNAL OF DISASTER PREVENTION AND MITIGATION ENGINEERING
2010年
2期
177-184
,共8页
拱坝横缝%拱坝键槽%地震响应
拱壩橫縫%拱壩鍵槽%地震響應
공패횡봉%공패건조%지진향응
contraction joint%key slot%seismic response
基于非线性指数型动接触本构模型,对实际键槽模型进行简化处理.采用的本构模型可以考虑缝面的开合非线性以及横缝键槽的咬合作用.采用点一面接触模型模拟横缝的非线性动接触行为,精细研究了缝面开度、径向位移的变化及其对坝体应力状态的影响,并与平缝结果进行了比较.以一座拟建的混凝土重力拱坝,探讨了横缝及其诱导缝对大坝工作性态的影响,并对横缝键槽的影响进行了综合分析.研究表明,横缝的径向滑移量要远大于开度,当考虑诱导缝时.由于大坝整体性受到削弱,横缝开度变大;考虑键槽效应后,径向滑移效应大幅减小,而法向开度增大,坝踵处的主拉应力以及拱冠梁顶处的拱向拉应力的最大值均变大.
基于非線性指數型動接觸本構模型,對實際鍵槽模型進行簡化處理.採用的本構模型可以攷慮縫麵的開閤非線性以及橫縫鍵槽的咬閤作用.採用點一麵接觸模型模擬橫縫的非線性動接觸行為,精細研究瞭縫麵開度、徑嚮位移的變化及其對壩體應力狀態的影響,併與平縫結果進行瞭比較.以一座擬建的混凝土重力拱壩,探討瞭橫縫及其誘導縫對大壩工作性態的影響,併對橫縫鍵槽的影響進行瞭綜閤分析.研究錶明,橫縫的徑嚮滑移量要遠大于開度,噹攷慮誘導縫時.由于大壩整體性受到削弱,橫縫開度變大;攷慮鍵槽效應後,徑嚮滑移效應大幅減小,而法嚮開度增大,壩踵處的主拉應力以及拱冠樑頂處的拱嚮拉應力的最大值均變大.
기우비선성지수형동접촉본구모형,대실제건조모형진행간화처리.채용적본구모형가이고필봉면적개합비선성이급횡봉건조적교합작용.채용점일면접촉모형모의횡봉적비선성동접촉행위,정세연구료봉면개도、경향위이적변화급기대패체응력상태적영향,병여평봉결과진행료비교.이일좌의건적혼응토중력공패,탐토료횡봉급기유도봉대대패공작성태적영향,병대횡봉건조적영향진행료종합분석.연구표명,횡봉적경향활이량요원대우개도,당고필유도봉시.유우대패정체성수도삭약,횡봉개도변대;고필건조효응후,경향활이효응대폭감소,이법향개도증대,패종처적주랍응력이급공관량정처적공향랍응력적최대치균변대.
The exponential nonlinear dynamic contact models,combined with point-to-surface contact models,are adopted for analyzing dynamic response of arch dam with key slots.Due to the complexity of the real structure of key slots,it needs to be simplified for the purpose of the research.Compared with the resuits of the flat joint models,the detailed studies of the key slot models concerns about the change law of the normal joint opening,the radial sliding and its effect on the dam stress states are carried out.A planning concrete arch dam as an instance is presented in the paper to discuss the effect of the contraction joint and induced joint on the work behavior of the dam.Additionally,the comprehensive analysis on the effect of key slot is also provided.The results show the radial slid of the arch dam with flat joints comparing to the normal opening is dominating,and the opening of contraction joints will increase with the induced joint which may weaken the stiffness and the integrity of the dam,but the induced joint have a less effect on the dam stress.Comparing with the flat joint models,the radial sliding of the key slot models will greatly decrease while the normal opening will increase;the maximum principal tension stress of the dam heel and the maximum arch stress of the crown cantilever crest will also increase.