中国组织工程研究与临床康复
中國組織工程研究與臨床康複
중국조직공정연구여림상강복
JOURNAL OF CLINICAL REHABILITATIVE TISSUE ENGINEERING RESEARCH
2007年
51期
10255-10259
,共5页
董扬%眭述平%王桂英%陈旸%鲍琨%江潮胤%曾炳芳
董颺%眭述平%王桂英%陳旸%鮑琨%江潮胤%曾炳芳
동양%휴술평%왕계영%진양%포곤%강조윤%증병방
胸椎%腰椎%正骨疗法%生物力学%组织构建
胸椎%腰椎%正骨療法%生物力學%組織構建
흉추%요추%정골요법%생물역학%조직구건
目的:对胸腰椎压缩性骨折的复位目前主要是通过Harrington棒的撑开或Dick等器械压缩,间接地使压缩的椎体得到复位.但复位的力量不易掌握,效果往往也不够理想.因此,需要了解和掌握复位器未发生变形时所能承受的最大应力及椎体复位器在椎体内撑开复位的应力与位移的关系.方法:实验于1998-10/2003-04在上海市材料力学研究所、上海市第九人民医院生物力学研究室及上海第二医科大学解剖教研室市生物力学研究室完成.自行设计的椎体复位器为圆柱形,顶端的上下开启由尾端的圆形手柄控制.实验方法:①椎体复位器的抗压力实验:将椎体复位器撑开到最大后进行轴向压缩实验,当复位器刚好发生形变时的轴向压应力,即是复位器进行轴向撑开时所能承受最大应力.②新鲜小牛骨椎体抗轴向压力实验:在36个新鲜小牛骨椎体上制作压缩性骨折模型时,了解椎体形变时的应力形变的关系.实验前测出每个椎体的高度值,发生压缩形变后,再测量每个椎体的高度值,并在机器上测出相应的压应力值.③椎体复位器复位压缩性小牛骨椎体的生物力学实验:将20个新鲜小牛骨胸腰椎椎体分成2组,每组10个椎体.在轴向载荷下压缩椎体,制作压缩性骨折的模型,1/2椎体高度压缩组其压缩后高度接近原有椎体高度的1/2,2/3椎体高度压缩组其压缩后高度接近原有椎体高度的2/3.从椎体椎弓根两侧放入复位器,将压缩的椎体予以复位.了解复位器在椎体内的撑开应力与复位时位移关系.结果:①复位器未发生变形时所能承受的最大力为281 N.②36个新鲜小牛骨椎体在承受轴向载荷发生变形时屈服点的平均应力为74.96 kPa,各数据符合正态分布(t=16.044,P<0.01).③1/2椎体高度压缩组和2/3椎体高度压缩组复位器在椎体内撑开后应力值差异无显著性意义(t=0.835,P>0.05).结论:椎体压缩程度与椎体内撑开复位的力量没有直接关系,自行设计的椎体复位器在椎体内撑开复位的力量远小于复位器的屈服点应力.
目的:對胸腰椎壓縮性骨摺的複位目前主要是通過Harrington棒的撐開或Dick等器械壓縮,間接地使壓縮的椎體得到複位.但複位的力量不易掌握,效果往往也不夠理想.因此,需要瞭解和掌握複位器未髮生變形時所能承受的最大應力及椎體複位器在椎體內撐開複位的應力與位移的關繫.方法:實驗于1998-10/2003-04在上海市材料力學研究所、上海市第九人民醫院生物力學研究室及上海第二醫科大學解剖教研室市生物力學研究室完成.自行設計的椎體複位器為圓柱形,頂耑的上下開啟由尾耑的圓形手柄控製.實驗方法:①椎體複位器的抗壓力實驗:將椎體複位器撐開到最大後進行軸嚮壓縮實驗,噹複位器剛好髮生形變時的軸嚮壓應力,即是複位器進行軸嚮撐開時所能承受最大應力.②新鮮小牛骨椎體抗軸嚮壓力實驗:在36箇新鮮小牛骨椎體上製作壓縮性骨摺模型時,瞭解椎體形變時的應力形變的關繫.實驗前測齣每箇椎體的高度值,髮生壓縮形變後,再測量每箇椎體的高度值,併在機器上測齣相應的壓應力值.③椎體複位器複位壓縮性小牛骨椎體的生物力學實驗:將20箇新鮮小牛骨胸腰椎椎體分成2組,每組10箇椎體.在軸嚮載荷下壓縮椎體,製作壓縮性骨摺的模型,1/2椎體高度壓縮組其壓縮後高度接近原有椎體高度的1/2,2/3椎體高度壓縮組其壓縮後高度接近原有椎體高度的2/3.從椎體椎弓根兩側放入複位器,將壓縮的椎體予以複位.瞭解複位器在椎體內的撐開應力與複位時位移關繫.結果:①複位器未髮生變形時所能承受的最大力為281 N.②36箇新鮮小牛骨椎體在承受軸嚮載荷髮生變形時屈服點的平均應力為74.96 kPa,各數據符閤正態分佈(t=16.044,P<0.01).③1/2椎體高度壓縮組和2/3椎體高度壓縮組複位器在椎體內撐開後應力值差異無顯著性意義(t=0.835,P>0.05).結論:椎體壓縮程度與椎體內撐開複位的力量沒有直接關繫,自行設計的椎體複位器在椎體內撐開複位的力量遠小于複位器的屈服點應力.
목적:대흉요추압축성골절적복위목전주요시통과Harrington봉적탱개혹Dick등기계압축,간접지사압축적추체득도복위.단복위적역량불역장악,효과왕왕야불구이상.인차,수요료해화장악복위기미발생변형시소능승수적최대응력급추체복위기재추체내탱개복위적응력여위이적관계.방법:실험우1998-10/2003-04재상해시재료역학연구소、상해시제구인민의원생물역학연구실급상해제이의과대학해부교연실시생물역학연구실완성.자행설계적추체복위기위원주형,정단적상하개계유미단적원형수병공제.실험방법:①추체복위기적항압력실험:장추체복위기탱개도최대후진행축향압축실험,당복위기강호발생형변시적축향압응력,즉시복위기진행축향탱개시소능승수최대응력.②신선소우골추체항축향압력실험:재36개신선소우골추체상제작압축성골절모형시,료해추체형변시적응력형변적관계.실험전측출매개추체적고도치,발생압축형변후,재측량매개추체적고도치,병재궤기상측출상응적압응력치.③추체복위기복위압축성소우골추체적생물역학실험:장20개신선소우골흉요추추체분성2조,매조10개추체.재축향재하하압축추체,제작압축성골절적모형,1/2추체고도압축조기압축후고도접근원유추체고도적1/2,2/3추체고도압축조기압축후고도접근원유추체고도적2/3.종추체추궁근량측방입복위기,장압축적추체여이복위.료해복위기재추체내적탱개응력여복위시위이관계.결과:①복위기미발생변형시소능승수적최대력위281 N.②36개신선소우골추체재승수축향재하발생변형시굴복점적평균응력위74.96 kPa,각수거부합정태분포(t=16.044,P<0.01).③1/2추체고도압축조화2/3추체고도압축조복위기재추체내탱개후응력치차이무현저성의의(t=0.835,P>0.05).결론:추체압축정도여추체내탱개복위적역량몰유직접관계,자행설계적추체복위기재추체내탱개복위적역량원소우복위기적굴복점응력.