CAJ | 학술논문

为提高复杂型面工件超声自动检测的效率和通用性，研究了CAD模型已知时工件的匹配定位方法。首先使用人工缺陷陷贴片的超声C扫描数据获取待匹配特征点的位姿。然后以工件3个角点为特征点进行初始定位，由2个局部坐标系匹配得到初始匹配矩阵。最后根据点到曲面的最小距离原则进行精匹配定位，使用循环迭代及Menq算法进行寻优求解。实例表明，选用6个采样点时，匹配误差可控制在0．4mm以内，能很好地满足复杂型面工件超声自动检测的精度要求。
위제고복잡형면공건초성자동검측적효솔화통용성，연구료CAD모형이지시공건적필배정위방법。수선사용인공결함함첩편적초성C소묘수거획취대필배특정점적위자。연후이공건3개각점위특정점진행초시정위，유2개국부좌표계필배득도초시필배구진。최후근거점도곡면적최소거리원칙진행정필배정위，사용순배질대급Menq산법진행심우구해。실례표명，선용6개채양점시，필배오차가공제재0．4mm이내，능흔호지만족복잡형면공건초성자동검측적정도요구。
To improve the efficiency and universality of automatic ultrasonic testing for complex surface parts,a matching and localization method was proposed when the CAD model of the part to be tested was given. The position of feature points to match by C--scan ultrasonic measurement data for artificial defect on the tested part was attained firstly. Then an approximate localization method using three corner points as feature points was studied;the initial matching matrix was calculated from the matching of the two local coordinate systems. Lastly,a precise localization was acquired according to the minimum distance principle from the point to the surface,and it was calculated by the cyclic itera- tive method and Menq algorithm. The results of an example show that the matching error is less than 0.4mm when selecting six sampling points,which can meet the accuracy requirement in automatic ul- trasonic testing for complex surface parts.