环境污染与防治
環境汙染與防治
배경오염여방치
ENVIRONMENTAL POLLUTION AND CONTROL
2012年
4期
5-10
,共6页
邹道安%黄瑾%白海龙%王飞%麻红磊%池涌
鄒道安%黃瑾%白海龍%王飛%痳紅磊%池湧
추도안%황근%백해룡%왕비%마홍뢰%지용
干化%污染气体%冷凝液%热重%燃烧特性
榦化%汙染氣體%冷凝液%熱重%燃燒特性
간화%오염기체%냉응액%열중%연소특성
分别在桨叶式干化机和热重仪上进行污泥干化和燃烧试验,研究了污泥干化特性和污染物排放特性,并对污泥的燃烧特性进行分析.结果表明,污泥干化过程分为黏稠区、粘滞区和颗粒区3个阶段.干化过程排放的污染气体有氨气、氯化氢、氟化氢、氰化氢、甲烷和挥发性有机酸等,其中氨气为主要污染气体,经冷凝吸收和活性炭吸附处理后,各种污染气体浓度均显著降低,其中氨气去除率最高,达97.04%.污泥干化冷凝液的BOD5和COD质量浓度分别为4 040、8 510 mg/L,氨氮的质量浓度为1 025mg/L,pH为9.84,属于高浓度有机废水.污泥的燃烧过程可以分为3个失重阶段:水分析出阶段(50~150℃),挥发分燃烧阶段(150~450℃),固定碳燃烧阶段(450~650℃).分别用Kissioger法和Ozawa法计算挥发分燃烧阶段和固定碳燃烧阶段的活化能和动力学方程,挥发分燃烧阶段的活化能低于固定碳燃烧阶段,表明挥发分燃烧阶段污泥更易燃烧.污泥的燃烧过程在650℃时基本完成,因此实际工程应用中,设计干化污泥的焚烧温度在750 ℃比较合理.
分彆在槳葉式榦化機和熱重儀上進行汙泥榦化和燃燒試驗,研究瞭汙泥榦化特性和汙染物排放特性,併對汙泥的燃燒特性進行分析.結果錶明,汙泥榦化過程分為黏稠區、粘滯區和顆粒區3箇階段.榦化過程排放的汙染氣體有氨氣、氯化氫、氟化氫、氰化氫、甲烷和揮髮性有機痠等,其中氨氣為主要汙染氣體,經冷凝吸收和活性炭吸附處理後,各種汙染氣體濃度均顯著降低,其中氨氣去除率最高,達97.04%.汙泥榦化冷凝液的BOD5和COD質量濃度分彆為4 040、8 510 mg/L,氨氮的質量濃度為1 025mg/L,pH為9.84,屬于高濃度有機廢水.汙泥的燃燒過程可以分為3箇失重階段:水分析齣階段(50~150℃),揮髮分燃燒階段(150~450℃),固定碳燃燒階段(450~650℃).分彆用Kissioger法和Ozawa法計算揮髮分燃燒階段和固定碳燃燒階段的活化能和動力學方程,揮髮分燃燒階段的活化能低于固定碳燃燒階段,錶明揮髮分燃燒階段汙泥更易燃燒.汙泥的燃燒過程在650℃時基本完成,因此實際工程應用中,設計榦化汙泥的焚燒溫度在750 ℃比較閤理.
분별재장협식간화궤화열중의상진행오니간화화연소시험,연구료오니간화특성화오염물배방특성,병대오니적연소특성진행분석.결과표명,오니간화과정분위점주구、점체구화과립구3개계단.간화과정배방적오염기체유안기、록화경、불화경、청화경、갑완화휘발성유궤산등,기중안기위주요오염기체,경냉응흡수화활성탄흡부처리후,각충오염기체농도균현저강저,기중안기거제솔최고,체97.04%.오니간화냉응액적BOD5화COD질량농도분별위4 040、8 510 mg/L,안담적질량농도위1 025mg/L,pH위9.84,속우고농도유궤폐수.오니적연소과정가이분위3개실중계단:수분석출계단(50~150℃),휘발분연소계단(150~450℃),고정탄연소계단(450~650℃).분별용Kissioger법화Ozawa법계산휘발분연소계단화고정탄연소계단적활화능화동역학방정,휘발분연소계단적활화능저우고정탄연소계단,표명휘발분연소계단오니경역연소.오니적연소과정재650℃시기본완성,인차실제공정응용중,설계간화오니적분소온도재750 ℃비교합리.