应用激光
應用激光
응용격광
APPLIED LASER
2009年
6期
502-506
,共5页
激光焊%热源模型%ANSYS模拟%焊缝截面形状
激光銲%熱源模型%ANSYS模擬%銲縫截麵形狀
격광한%열원모형%ANSYS모의%한봉절면형상
laser welding%heat source model%ANSYS simulation%weld cross-section shape
通过实际施焊试验,优选出1.2mm厚不锈钢板对接激光焊的焊接工艺参数,用该参数在ANSYS有限元分析软件中对其焊接温度场进行了模拟.建立高斯表面热源与双椭球体热源叠加的组合热源模型,通过对焊缝截面形状的比较探讨了该组合热源中的两种热源模型的功率分配.选用面热源与体热源功率之比为3∶7时模拟出的焊缝截面形状与实际施焊的结果最为接近,并且显著优于采用单个热源模型加热时的模拟结果.
通過實際施銲試驗,優選齣1.2mm厚不鏽鋼闆對接激光銲的銲接工藝參數,用該參數在ANSYS有限元分析軟件中對其銲接溫度場進行瞭模擬.建立高斯錶麵熱源與雙橢毬體熱源疊加的組閤熱源模型,通過對銲縫截麵形狀的比較探討瞭該組閤熱源中的兩種熱源模型的功率分配.選用麵熱源與體熱源功率之比為3∶7時模擬齣的銲縫截麵形狀與實際施銲的結果最為接近,併且顯著優于採用單箇熱源模型加熱時的模擬結果.
통과실제시한시험,우선출1.2mm후불수강판대접격광한적한접공예삼수,용해삼수재ANSYS유한원분석연건중대기한접온도장진행료모의.건립고사표면열원여쌍타구체열원첩가적조합열원모형,통과대한봉절면형상적비교탐토료해조합열원중적량충열원모형적공솔분배.선용면열원여체열원공솔지비위3∶7시모의출적한봉절면형상여실제시한적결과최위접근,병차현저우우채용단개열원모형가열시적모의결과.
Butt laser welding parameters of 1.2mm thick stainless steel plate are selected by practical welding test, welding temperature field based on the parameters is simulated by finite element software ANSYS. A combination of heat source model is established, which is superimposed by the gauss plane heat source and the double ellipsoid volumetric heating source, the power distribution of the combination of heat source model is explored through comparison of weld cross-section shape. While the power of plane heat source and volumetric heating source is at the ratio of 3∶7, the simulated results of the weld cross-section shape is most close to the actual results, which is significantly better than the simulated results of a single heat source model during heating.