深圳大学学报(理工版)
深圳大學學報(理工版)
심수대학학보(리공판)
JOURNAL OF SHENZHEN UNIVERSITY (SCIENCE & ENGINEERING)
2010年
1期
95-102
,共8页
结构工程%轴压比%组合柱延性%高强混凝土%抗震设计
結構工程%軸壓比%組閤柱延性%高彊混凝土%抗震設計
결구공정%축압비%조합주연성%고강혼응토%항진설계
structural engineering%axial compression ratio%composite column ductility%high-strength concrete%seismic design
以轴压比为主要参数,对14根反复荷载作用下的钢骨-方钢管高强混凝土柱进行研究.结果表明,钢骨的加入使方钢管高强混凝土柱的位移延性系数显著提高,但轴压比仍是影响其组合柱延性的主要因素;组合柱的位移延性系数μ_Δ介于2.54~3.84.这表明当内填混凝土强度很高时,为满足抗震设计的要求,有必要对其轴压比的限值作出规定.通过试验轴压比与设计轴压比的换算,提出在满足组合柱有限延性基础上(μ_Δ≥3)轴压比的限值.
以軸壓比為主要參數,對14根反複荷載作用下的鋼骨-方鋼管高彊混凝土柱進行研究.結果錶明,鋼骨的加入使方鋼管高彊混凝土柱的位移延性繫數顯著提高,但軸壓比仍是影響其組閤柱延性的主要因素;組閤柱的位移延性繫數μ_Δ介于2.54~3.84.這錶明噹內填混凝土彊度很高時,為滿足抗震設計的要求,有必要對其軸壓比的限值作齣規定.通過試驗軸壓比與設計軸壓比的換算,提齣在滿足組閤柱有限延性基礎上(μ_Δ≥3)軸壓比的限值.
이축압비위주요삼수,대14근반복하재작용하적강골-방강관고강혼응토주진행연구.결과표명,강골적가입사방강관고강혼응토주적위이연성계수현저제고,단축압비잉시영향기조합주연성적주요인소;조합주적위이연성계수μ_Δ개우2.54~3.84.저표명당내전혼응토강도흔고시,위만족항진설계적요구,유필요대기축압비적한치작출규정.통과시험축압비여설계축압비적환산,제출재만족조합주유한연성기출상(μ_Δ≥3)축압비적한치.
Fourteen square steel tube specimens filled with steel-reinforced high-strength concrete were tested under combined high axial load and cyclic lateral force.Axial compression ratio was the main test parameter.Test results show that the inserted steel section in square steel tubes filled with high-strength concrete can significantly improve the ductility of the composite columns,but axial compression ratio is still the most important factor that affects the ductility of the composite columns;Displacement ductility coefficients (μ_Δ) of the composite columns in the test are concentrated between 2.54 and 3.84.This means that when the strength of the in-filled concrete is high,it is necessary to limit the axial load ratio to satisfy the ductility demand for seismic design of the composite columns.Finally,the limit value of the axial compression ratio is proposed on the basis of satisfying finite ductility of the composite columns(μ_Δ≥3)through the conversion formula between test axial compression ratio and design axial compression ratio.