航空学报
航空學報
항공학보
ACTA AERONAUTICA ET ASTRONAUTICA SINICA
2001年
2期
187-189
,共3页
陈敦军%吴诗%向毅斌%李淼泉
陳敦軍%吳詩%嚮毅斌%李淼泉
진돈군%오시%향의빈%리묘천
钛合金%板材%激光弯曲%热应力%温度梯度%弯曲角度
鈦閤金%闆材%激光彎麯%熱應力%溫度梯度%彎麯角度
태합금%판재%격광만곡%열응력%온도제도%만곡각도
对常温下钛合金板材进行了激光弯曲成形研究。分析了激光功率、扫描速度、光斑大小对板材弯曲变形的影响,获得理想工艺参数范围为:功率1.0~1.2kW、扫描速度2~3m/min、光斑直径6~7mm。同时分析了板材厚度、宽度及扫描次数对材料弯曲变形的影响,为钛合金板材弯曲成形提供了一种新途径。
對常溫下鈦閤金闆材進行瞭激光彎麯成形研究。分析瞭激光功率、掃描速度、光斑大小對闆材彎麯變形的影響,穫得理想工藝參數範圍為:功率1.0~1.2kW、掃描速度2~3m/min、光斑直徑6~7mm。同時分析瞭闆材厚度、寬度及掃描次數對材料彎麯變形的影響,為鈦閤金闆材彎麯成形提供瞭一種新途徑。
대상온하태합금판재진행료격광만곡성형연구。분석료격광공솔、소묘속도、광반대소대판재만곡변형적영향,획득이상공예삼수범위위:공솔1.0~1.2kW、소묘속도2~3m/min、광반직경6~7mm。동시분석료판재후도、관도급소묘차수대재료만곡변형적영향,위태합금판재만곡성형제공료일충신도경。
In this paper, laser bending process of titanium alloy sheets which are difficult to be deformed at normal temperature has been carried out. The effects of process parameters and geometry of sheets on the bending angle of sheets have been studied. The results show that:(i)the following process parameters ranges for laser bending of titanium ally sheets are optimum:1.0~1.2kW for laser power, 2~3m/min for scanning velocity and 6~7mm for laster spot diameter; (ii)the bending angle after one time scanning decreases with an increasing thickness of sheet and increases with an increasing width of sheet;(iii)the bending angle after the first scan is in proportion to the number of laser scans. Laser bending is a flexible manufacturing process without an external force and die being induced, and it is very useful for the forming of hard deformed and brittle material due to its character of accumulative little deformation.