化工科技
化工科技
화공과기
SCIENCE & TECHNOLOGY IN CHEMICAL INDUSY
2007年
5期
10-14
,共5页
马刚%冼国勇%张峥嵘%黄少斌
馬剛%冼國勇%張崢嶸%黃少斌
마강%승국용%장쟁영%황소빈
污泥稳定化%污泥无害化%预热自热高温好氧消化工艺%间歇式运行
汙泥穩定化%汙泥無害化%預熱自熱高溫好氧消化工藝%間歇式運行
오니은정화%오니무해화%예열자열고온호양소화공예%간헐식운행
用自行设计的预热自热高温好氧消化工艺系统处理市政污泥,采用间歇式运行方式,对不同的进泥浓度、搅拌速率、曝气量、固体停留时间条件下的污泥稳定化效果进行了单因素分析研究,获得最佳工艺参数,在此基础上,对污泥稳定化和无害化效果进行了评价,同时对消化后污泥的脱水性能、总氮、总磷、氨氮、总有机碳和pH值进行了测试分析.结果表明,当进泥含固率为4%~6%、进泥挥发性有机物浓度为(31.9~42.1)g/L、搅拌速率为(90~100)r/min、曝气量为(0.06~0.08)m3/h、固体停留时间为10 d时,污泥稳定化效果最好,反应器内温度可维持在55~57℃,对挥发性有机物的去除率平均达到52.8%,此时,病原菌的灭活率达到100%,出泥达到了美国环保局规定的A级生物固体(污泥)的标准;在此最佳工艺条件下发现消化后的污泥脱水性能变差,而总氮、总磷、氨氮、总有机碳和pH值升高,这是由于在消化过程中产生的溶胞现象所致.
用自行設計的預熱自熱高溫好氧消化工藝繫統處理市政汙泥,採用間歇式運行方式,對不同的進泥濃度、攪拌速率、曝氣量、固體停留時間條件下的汙泥穩定化效果進行瞭單因素分析研究,穫得最佳工藝參數,在此基礎上,對汙泥穩定化和無害化效果進行瞭評價,同時對消化後汙泥的脫水性能、總氮、總燐、氨氮、總有機碳和pH值進行瞭測試分析.結果錶明,噹進泥含固率為4%~6%、進泥揮髮性有機物濃度為(31.9~42.1)g/L、攪拌速率為(90~100)r/min、曝氣量為(0.06~0.08)m3/h、固體停留時間為10 d時,汙泥穩定化效果最好,反應器內溫度可維持在55~57℃,對揮髮性有機物的去除率平均達到52.8%,此時,病原菌的滅活率達到100%,齣泥達到瞭美國環保跼規定的A級生物固體(汙泥)的標準;在此最佳工藝條件下髮現消化後的汙泥脫水性能變差,而總氮、總燐、氨氮、總有機碳和pH值升高,這是由于在消化過程中產生的溶胞現象所緻.
용자행설계적예열자열고온호양소화공예계통처리시정오니,채용간헐식운행방식,대불동적진니농도、교반속솔、폭기량、고체정류시간조건하적오니은정화효과진행료단인소분석연구,획득최가공예삼수,재차기출상,대오니은정화화무해화효과진행료평개,동시대소화후오니적탈수성능、총담、총린、안담、총유궤탄화pH치진행료측시분석.결과표명,당진니함고솔위4%~6%、진니휘발성유궤물농도위(31.9~42.1)g/L、교반속솔위(90~100)r/min、폭기량위(0.06~0.08)m3/h、고체정류시간위10 d시,오니은정화효과최호,반응기내온도가유지재55~57℃,대휘발성유궤물적거제솔평균체도52.8%,차시,병원균적멸활솔체도100%,출니체도료미국배보국규정적A급생물고체(오니)적표준;재차최가공예조건하발현소화후적오니탈수성능변차,이총담、총린、안담、총유궤탄화pH치승고,저시유우재소화과정중산생적용포현상소치.