CAJ | 학술논문

针对纳米结构表征和纳米制造的质量控制需要,中国计量科学研究院设计并搭建了一台计量型原子力显微镜用于纳米几何结构的测量.为了将位移精确溯源到国际单位米,研制了单频8倍程干涉仪测量位移,样品表面形貌则由接触式原子力显微镜测量.一个立方体反射镜与原子力显微镜的测头固定,作为干涉仪的参考镜.两个互相垂直的干涉仪用于测量样品与探针在x-y方向的相对位置.样品台置于具有三面反射镜的零膨胀玻璃块上,由压电陶瓷位移台驱动.另外两台干涉仪测量样品与探针在z方向的位移,探针针尖位于干涉仪光束的交点以减小Abbe误差.由于光学器件的缺陷产生的相位混合会引起非线性误差,采用谐波分离法拟合干涉信号来修正误差,修正后干涉仪测量误差减小为0.7 nm.
침대납미결구표정화납미제조적질량공제수요,중국계량과학연구원설계병탑건료일태계량형원자력현미경용우납미궤하결구적측량.위료장위이정학소원도국제단위미,연제료단빈8배정간섭의측량위이,양품표면형모칙유접촉식원자력현미경측량.일개립방체반사경여원자력현미경적측두고정,작위간섭의적삼고경.량개호상수직적간섭의용우측량양품여탐침재x-y방향적상대위치.양품태치우구유삼면반사경적령팽창파리괴상,유압전도자위이태구동.령외량태간섭의측량양품여탐침재z방향적위이,탐침침첨위우간섭의광속적교점이감소Abbe오차.유우광학기건적결함산생적상위혼합회인기비선성오차,채용해파분리법의합간섭신호래수정오차,수정후간섭의측량오차감소위0.7 nm.
For characterizing the nanostructure and controlling nano-manufacturing quality,a metrological Atomic Force Microscope(AFM) was designed and constructed in National Institute of Metrology.To trace the displacement to the SI unit,the relative position of sample and AFM probe is measured with homodyne 8-pass interferometers and the surface topology of the sample is measured by AFM at a contact mode.A cube with mirrors is fixed on the probe as the reference mirror of interferometers,so that the relative displacement of probe in the x-y direction to the sample is measured by interferometers.The sample stage is fixed on a corner block with mirrors on three sides and driven by a piezoelectric motion stage.Two interferometers is used to measure the displacement of sample and probe in z direction.The probe tip is positioned in the intersection of the interferometers in 3 directions to minimize the Abbe error.As the phase mixing from the defect of optical element will cause the nonlinear error,a harmonic separation method is introduced to fit the inteferometric signals and to correct the error.The measured results show that the nonlinear error has been reduced to 0.7 nm,which demonstrates this system has better performance.