建筑材料学报
建築材料學報
건축재료학보
JOURNAL OF BUILDING MATERIALS
2010年
4期
524-528
,共5页
付亚伟%蔡良才%曹定国%吴永根
付亞偉%蔡良纔%曹定國%吳永根
부아위%채량재%조정국%오영근
无机聚合物混凝土%激发剂%矿粉%制备%水化程度%微观结构
無機聚閤物混凝土%激髮劑%礦粉%製備%水化程度%微觀結構
무궤취합물혼응토%격발제%광분%제비%수화정도%미관결구
以矿粉为原料,掺入Na2SiO3和NaOH复合激发剂,制备了大流动度、早强高强无机聚合物混凝土(MPC).探讨了MPC的制备工艺及矿粉用量、溶胶比对MPC性能的影响规律,并通过烧失量试验、SEM和EDS分析了MPC各龄期的水化程度、微观结构及强度机理.结果表明:激发剂显著提高了矿粉的活性,MPC水化1d后其水化程度已达52%,并随龄期的延长逐渐加大;MPC水化产物和结构较密实,浆体中C-S-H凝胶、碱性铝硅酸盐水化物和沸石型矿物含量较多,Ca(OH)2含量显著降低,晶体的整体性提高,胶结料和集料的界面强度较大;MPC 28d抗折、抗压强度最高分别达8.51,91.9MPa,且强度发展较快,7d抗折、抗压强度最高分别达7.59,84.8MPa,且各龄期的强度均随矿粉用量或溶胶比的提高而降低;各制备参数对MPC工作性影响程度为:矿粉用量>溶胶比>砂率,在其他条件相同时,MPC坍落度随着矿粉用量或溶胶比的增加而增加,能达到160mm以上.
以礦粉為原料,摻入Na2SiO3和NaOH複閤激髮劑,製備瞭大流動度、早彊高彊無機聚閤物混凝土(MPC).探討瞭MPC的製備工藝及礦粉用量、溶膠比對MPC性能的影響規律,併通過燒失量試驗、SEM和EDS分析瞭MPC各齡期的水化程度、微觀結構及彊度機理.結果錶明:激髮劑顯著提高瞭礦粉的活性,MPC水化1d後其水化程度已達52%,併隨齡期的延長逐漸加大;MPC水化產物和結構較密實,漿體中C-S-H凝膠、堿性鋁硅痠鹽水化物和沸石型礦物含量較多,Ca(OH)2含量顯著降低,晶體的整體性提高,膠結料和集料的界麵彊度較大;MPC 28d抗摺、抗壓彊度最高分彆達8.51,91.9MPa,且彊度髮展較快,7d抗摺、抗壓彊度最高分彆達7.59,84.8MPa,且各齡期的彊度均隨礦粉用量或溶膠比的提高而降低;各製備參數對MPC工作性影響程度為:礦粉用量>溶膠比>砂率,在其他條件相同時,MPC坍落度隨著礦粉用量或溶膠比的增加而增加,能達到160mm以上.
이광분위원료,참입Na2SiO3화NaOH복합격발제,제비료대류동도、조강고강무궤취합물혼응토(MPC).탐토료MPC적제비공예급광분용량、용효비대MPC성능적영향규률,병통과소실량시험、SEM화EDS분석료MPC각령기적수화정도、미관결구급강도궤리.결과표명:격발제현저제고료광분적활성,MPC수화1d후기수화정도이체52%,병수령기적연장축점가대;MPC수화산물화결구교밀실,장체중C-S-H응효、감성려규산염수화물화비석형광물함량교다,Ca(OH)2함량현저강저,정체적정체성제고,효결료화집료적계면강도교대;MPC 28d항절、항압강도최고분별체8.51,91.9MPa,차강도발전교쾌,7d항절、항압강도최고분별체7.59,84.8MPa,차각령기적강도균수광분용량혹용효비적제고이강저;각제비삼수대MPC공작성영향정도위:광분용량>용효비>사솔,재기타조건상동시,MPC담락도수착광분용량혹용효비적증가이증가,능체도160mm이상.