广东化工
廣東化工
엄동화공
GUANGDONG CHEMICAL INDUSTRY
2012年
3期
236-237,240
,共3页
林旭龙%崔家琪%赵小华%汪晓军
林旭龍%崔傢琪%趙小華%汪曉軍
림욱룡%최가기%조소화%왕효군
印染废水%混凝%脱色
印染廢水%混凝%脫色
인염폐수%혼응%탈색
dyeing wastewater%coagulation: decolorization
采用佛山市南海西樵纺织工业园园区的印染废水进行混凝脱色处理研究,对硫酸亚铁(FeSO4)、聚合氯化铝(PAC)及双氰胺-甲醛(F3)脱色剂和阳离子有机脱色剂(A6)进行混凝脱色性能测试和成本分析。结果表明,A6脱色剂产泥量少,处理成本较低,能够较好地脱除原水的COD和色度,在投加量为20mg/L下,COD去除率和色度去除率分别为32.7%和76.9%。实际运行结果中,平均COD去除率为39.4%,平均色度去除率达到90%以上。
採用彿山市南海西樵紡織工業園園區的印染廢水進行混凝脫色處理研究,對硫痠亞鐵(FeSO4)、聚閤氯化鋁(PAC)及雙氰胺-甲醛(F3)脫色劑和暘離子有機脫色劑(A6)進行混凝脫色性能測試和成本分析。結果錶明,A6脫色劑產泥量少,處理成本較低,能夠較好地脫除原水的COD和色度,在投加量為20mg/L下,COD去除率和色度去除率分彆為32.7%和76.9%。實際運行結果中,平均COD去除率為39.4%,平均色度去除率達到90%以上。
채용불산시남해서초방직공업완완구적인염폐수진행혼응탈색처리연구,대류산아철(FeSO4)、취합록화려(PAC)급쌍청알-갑철(F3)탈색제화양리자유궤탈색제(A6)진행혼응탈색성능측시화성본분석。결과표명,A6탈색제산니량소,처리성본교저,능구교호지탈제원수적COD화색도,재투가량위20mg/L하,COD거제솔화색도거제솔분별위32.7%화76.9%。실제운행결과중,평균COD거제솔위39.4%,평균색도거제솔체도90%이상。
The dyeing wastewater of Foshan Xiqiao Textile industry Park was treated by coagulation and biological processes. The coagulation and decolorization performance and the cost were analyzed by ferrous sulfate (FeSO4), polymeric aluminium (PAC), F3 decolorizer and A6 decolorizer. The result showed that the A6 decolorizer produces less sludge, lower cost and better treatment results for removing the COD and color from raw water. In the dosage of 20mg/L, the COD and color removal rate were 32.7 % and76.9 %, respectively. In practical operation, the average COD removal rate was 39.4 %, and the color removal rate was more than 90 %.