中华骨科杂志
中華骨科雜誌
중화골과잡지
CHINESE JOURNAL OF ORTHOPAEDICS
2009年
1期
2-6
,共5页
郝永宏%邓树才%马毅%孙志明%吉宁%贾占华%李建江%刘建坤%赵合元%周静
郝永宏%鄧樹纔%馬毅%孫誌明%吉寧%賈佔華%李建江%劉建坤%趙閤元%週靜
학영굉%산수재%마의%손지명%길저%가점화%리건강%류건곤%조합원%주정
脊柱骨折%骨螺丝%治疗结果
脊柱骨摺%骨螺絲%治療結果
척주골절%골라사%치료결과
Spinal fractures%Bone screws%Treatment outcome
目的 探讨经后路椎体次全切除、钛网及椎弓根钉重建术治疗严重胸腰椎骨折的临床价值.方法 2006年1月至2007年8月,对36例严重胸腰椎骨折患者采用本术式治疗.按AO骨折分型,均为A3亚型;术前神经功能ASIA分级:A级8例,B级16例,C级8例,D级4例.手术采用后正中入路,显露伤椎及其上、下邻椎的椎板、关节突及椎弓根钉进钉点,在上、下邻椎内置入椎弓根钉,通过椎弓根内同定试行撑开复位或矫正脊柱序列,临时固定.切除伤椎椎板及相关的关节突间关节,切除一侧或双侧椎弓根内缘创建后外侧工作通道,然后通过后外侧工作通道用骨刀对伤椎进行适当的壳内次全切除,并将钛网置人伤椎椎体次全切除后的骨缺损区,透视满意后加压椎弓根钉使钛网牢固.通过比较术前、术后和随访时X线及CT片上Cobb角和骨块椎管占位比例来评价后凸畸形矫正情况、椎管减压程度及植骨融合情况.结果 术后随访12~24个月,平均18个月.所有患者在术后12个月时ASIA神经功能分级均有1级或1级以上的恢复.术后12个月时X线和CT片显示减压和复位效果满意.脊柱序列恢复正常,植骨融合率为97.3%.35例患者无继发性后凸畸形.1例患者出现钛网塌陷及后凸畸形.结论 经后路椎体次全切除、钛网及椎弓根钉重建术可结合前后路手术优势,一个切口一次完成减压、复位、固定、融合,重建三柱的稳定性;但尚须大宗病例的积累及长期随访验证.
目的 探討經後路椎體次全切除、鈦網及椎弓根釘重建術治療嚴重胸腰椎骨摺的臨床價值.方法 2006年1月至2007年8月,對36例嚴重胸腰椎骨摺患者採用本術式治療.按AO骨摺分型,均為A3亞型;術前神經功能ASIA分級:A級8例,B級16例,C級8例,D級4例.手術採用後正中入路,顯露傷椎及其上、下鄰椎的椎闆、關節突及椎弓根釘進釘點,在上、下鄰椎內置入椎弓根釘,通過椎弓根內同定試行撐開複位或矯正脊柱序列,臨時固定.切除傷椎椎闆及相關的關節突間關節,切除一側或雙側椎弓根內緣創建後外側工作通道,然後通過後外側工作通道用骨刀對傷椎進行適噹的殼內次全切除,併將鈦網置人傷椎椎體次全切除後的骨缺損區,透視滿意後加壓椎弓根釘使鈦網牢固.通過比較術前、術後和隨訪時X線及CT片上Cobb角和骨塊椎管佔位比例來評價後凸畸形矯正情況、椎管減壓程度及植骨融閤情況.結果 術後隨訪12~24箇月,平均18箇月.所有患者在術後12箇月時ASIA神經功能分級均有1級或1級以上的恢複.術後12箇月時X線和CT片顯示減壓和複位效果滿意.脊柱序列恢複正常,植骨融閤率為97.3%.35例患者無繼髮性後凸畸形.1例患者齣現鈦網塌陷及後凸畸形.結論 經後路椎體次全切除、鈦網及椎弓根釘重建術可結閤前後路手術優勢,一箇切口一次完成減壓、複位、固定、融閤,重建三柱的穩定性;但尚鬚大宗病例的積纍及長期隨訪驗證.
목적 탐토경후로추체차전절제、태망급추궁근정중건술치료엄중흉요추골절적림상개치.방법 2006년1월지2007년8월,대36례엄중흉요추골절환자채용본술식치료.안AO골절분형,균위A3아형;술전신경공능ASIA분급:A급8례,B급16례,C급8례,D급4례.수술채용후정중입로,현로상추급기상、하린추적추판、관절돌급추궁근정진정점,재상、하린추내치입추궁근정,통과추궁근내동정시행탱개복위혹교정척주서렬,림시고정.절제상추추판급상관적관절돌간관절,절제일측혹쌍측추궁근내연창건후외측공작통도,연후통과후외측공작통도용골도대상추진행괄당적각내차전절제,병장태망치인상추추체차전절제후적골결손구,투시만의후가압추궁근정사태망뢰고.통과비교술전、술후화수방시X선급CT편상Cobb각화골괴추관점위비례래평개후철기형교정정황、추관감압정도급식골융합정황.결과 술후수방12~24개월,평균18개월.소유환자재술후12개월시ASIA신경공능분급균유1급혹1급이상적회복.술후12개월시X선화CT편현시감압화복위효과만의.척주서렬회복정상,식골융합솔위97.3%.35례환자무계발성후철기형.1례환자출현태망탑함급후철기형.결론 경후로추체차전절제、태망급추궁근정중건술가결합전후로수술우세,일개절구일차완성감압、복위、고정、융합,중건삼주적은정성;단상수대종병례적적루급장기수방험증.
Objective To analyze the results of subtotal corpectomy with titanium mesh implantation and pedicle screw fixation by posterior approach for severe thoracic and lumbar fracture.Methods From January 2006 to August 2007, 36 patients with severe thoracic and lumbar fracture were treated.According to AO classification, all patients were A3.According to ASIA, there were 8 cases for grade A, 16 cases for grade B, 8 cases for grade C, 4 cases for grade D.A posterior midline incision was taken for this surgery.The laminae of the injured vertebra and adjacent upper and lower vertebrae as well the facets and screw entry points were exposed.Then pedicle screws were put into the upper and lower vertebrae and a distraction reduction was tried to restore spinal alignment for temporary fixation.The lamina of the injured vertebra and relevant facet joints were resected.And also unilateral or bilateral medial part of pedicle was removed to build a posterolateral working pathway.Through this pathway a subtotal corpectomy was done and a titanium mesh with suitable size was implanted.The titanium mesh was fastened by compressing the pedicle screws after a satisfactory fluoroscopy.The efficacy of treatment was assessed by evaluation of the Cobb angle restoration and reduction of canal compromise.Results All these surgeries were performed successfully without any neurological deterioration.The 36 cases were followed up for 12 to 24 months (18 months on average).Neurological status of all patients improved at least 1 ASIA grade at 12 months postoperatively.35 patients obtained bony fusion.During follow-up, lumbar physical lordosis was reconstructed and no evident correction loss, fusion rate was 97.3%.One patient appeared titanium mesh sink and kyphosis recurrence.Conclusion One-stage combined anteroposterior surgery can be accomplished in a prone position.It was proved to be an effective treatment for severe thoracic and lumbar fracture.