CAJ | 학술논문

采用光纤激光器对血管支架进行了激光切割工艺研究,通过实验获得了聚焦透镜焦距及焦点位置、输出功率、切割速度、脉冲频率、脉冲宽度、辅助气体种类及压强等工艺参数对切缝宽度和缝面质量的影响规律.结果表明:缝宽随输出功率、频率、脉宽及辅助氧压的增大而增加,随着切割速度的增加而减小.在实验的基础上找出了血管支架切割的最佳工艺参数,在316LVM不锈钢细管上(管壁厚度为0.12 mm,直径为2 mm)获得了切缝均匀,缝宽小于20 μm网状结构的血管支架.
채용광섬격광기대혈관지가진행료격광절할공예연구,통과실험획득료취초투경초거급초점위치、수출공솔、절할속도、맥충빈솔、맥충관도、보조기체충류급압강등공예삼수대절봉관도화봉면질량적영향규률.결과표명:봉관수수출공솔、빈솔、맥관급보조양압적증대이증가,수착절할속도적증가이감소.재실험적기출상조출료혈관지가절할적최가공예삼수,재316LVM불수강세관상(관벽후도위0.12 mm,직경위2 mm)획득료절봉균균,봉관소우20 μm망상결구적혈관지가.
The technical study of laser cutting for cardiovascular stents was fulfilled. It is a typical application of laser micro-fabrication. The discipline of influence of the technological parameters (including the focal length of lens, focus position, laser power, cutting speed, pulse frequency, pulse width and assist gas pressure) on the quality of the cardiovascular stents were obtained with the most advanced fiber laser in the world. The results show that the kerf width increases with the increase of laser power, pulse frequency, pulse width and assist gas pressure, but decreases with the increase of cutting speed. The optimal technological parameters for cutting cardiovascular stents with laser were acquired on the base of the experiment. Stents whose kerf width is less than 20 μm were cut after a lot of experiments.