模具技术
模具技術
모구기술
DIE AND MOULD TECHNOLOGY
2001年
1期
11-13,21
,共4页
王彬芳%温建勇%李建军%肖祥芷
王彬芳%溫建勇%李建軍%肖祥芷
왕빈방%온건용%리건군%초상지
级进模%组合件%CAD
級進模%組閤件%CAD
급진모%조합건%CAD
针对级进模中存在大量的标准件和典型结构这一特点,提出一基于3D组合件的级进模设计方法,并以此为基础,在UGII上开发出相应的3D级进模CAD系统。
針對級進模中存在大量的標準件和典型結構這一特點,提齣一基于3D組閤件的級進模設計方法,併以此為基礎,在UGII上開髮齣相應的3D級進模CAD繫統。
침대급진모중존재대량적표준건화전형결구저일특점,제출일기우3D조합건적급진모설계방법,병이차위기출,재UGII상개발출상응적3D급진모CAD계통。
This paper presents a research on the development of CAD forprogressive dies. Since there are many typical structures and standard parts used within a progressive die, A scheme that utilizes 3D insert-groups to design progressive die is proposed based on the UG16.0 platform.