电镀与精饰
電鍍與精飾
전도여정식
PLATING & FINISHING
2001年
2期
5-8
,共4页
锌铬膜%涂料%工艺%添加剂
鋅鉻膜%塗料%工藝%添加劑
자락막%도료%공예%첨가제
初步研究了锌铬膜工艺条件。首先初步确定了锌铬膜涂料中锌粉、铬酐和硼酸的含量，筛选出两种有效的还原剂R1和R2并初步确定了其含量。之后利用正交实验研究了锌铬膜涂料基本组成的最佳配比。最后筛选出添加剂A有效提高了锌铬膜的结合力。指出了锌铬膜工艺下一步研究的重点。
初步研究瞭鋅鉻膜工藝條件。首先初步確定瞭鋅鉻膜塗料中鋅粉、鉻酐和硼痠的含量，篩選齣兩種有效的還原劑R1和R2併初步確定瞭其含量。之後利用正交實驗研究瞭鋅鉻膜塗料基本組成的最佳配比。最後篩選齣添加劑A有效提高瞭鋅鉻膜的結閤力。指齣瞭鋅鉻膜工藝下一步研究的重點。
초보연구료자락막공예조건。수선초보학정료자락막도료중자분、락항화붕산적함량，사선출량충유효적환원제R1화R2병초보학정료기함량。지후이용정교실험연구료자락막도료기본조성적최가배비。최후사선출첨가제A유효제고료자락막적결합력。지출료자락막공예하일보연구적중점。
The technique of Zn-Cr coating was preliminary studied in this paper. Firstly, the contents of zinc powder, CrO3 and H3BO3 in the Zn-Cr coating paint were preliminary studied. The two kinds of reductant R1 and R2 were selected and the contents of them were determined. Then the optimum composition of the Zn-Cr coating paint was researched. At last, the additive A was selected to improve the adhesion of the coating. Further research efforts were pointed out.
