CAJ | 학술논문

利用气浮-生化-混凝沉淀工艺对电镀废水中的有机污染物进行处理,探讨了各工艺参数对COD去除效果的影响.实验结果表明:气浮处理在减轻后续接触氧化反应器的运行负荷的同时也提高了整个工艺的抗冲击能力.COD去除率随气浮时间的增加而增加,当气浮时间为70min时,COD去除率17.5%.在生化处理阶段,当HRT=10h、DO=4mg/L、pH=7和温度为30℃时,COD去除率55%.实验还研究了pH、PAM和聚铝浓度对混凝沉淀结果的影响,发现pH=9、PAM质量浓度为0.25 mg/L、聚铝为2 mg/L时,COD去除率11%.最终的实验结果表明:经该工艺处理后的废水,总COD去除率67.6%,出水COD为80 mg/L,达到国家新的排放标准(GB 21900-2008).
이용기부-생화-혼응침정공예대전도폐수중적유궤오염물진행처리,탐토료각공예삼수대COD거제효과적영향.실험결과표명:기부처리재감경후속접촉양화반응기적운행부하적동시야제고료정개공예적항충격능력.COD거제솔수기부시간적증가이증가,당기부시간위70min시,COD거제솔17.5%.재생화처리계단,당HRT=10h、DO=4mg/L、pH=7화온도위30℃시,COD거제솔55%.실험환연구료pH、PAM화취려농도대혼응침정결과적영향,발현pH=9、PAM질량농도위0.25 mg/L、취려위2 mg/L시,COD거제솔11%.최종적실험결과표명:경해공예처리후적폐수,총COD거제솔67.6%,출수COD위80 mg/L,체도국가신적배방표준(GB 21900-2008).
Electroplating wastewater has been treated by air-floatation-biochemical treatment-coagulative precipitation process. The effect of the parameters on the wastewater COD removal is discussed. The experimental results show that air-floatation can not only decrease the running load of the sequent contact oxidation reactor COD, but improve the impact resistance capacity of the whole process. The COD removal rate increases with the increase of air-floatation time. The COD removal rate reaches 17.5%, when air-floatation time is 60 min. During biochemical treatment, the COD removal rate reaches 55% when HRT, DO, pH and temperature are 10 h, 4 mg/L, 7 and 30℃, respectively. The effects of pH, PAM and polyaluminum concentration on coagulative precipitation has also been studied. The results indicates that the optional conditions are obtained as pH=9, PAM concentration 0.25 mg/L and polyaluminum concentration 2 mg/L, by which the COD removal rate reaches 11%. The final results show that the total COD removal rate reaches 67.6% and the effluent COD reaches 80 mg/L, which meets the newest National Discharge Standard (GB 21900-2008).