CAJ | 학술논문

提出了一种新的动平衡测试方法，即在精密离心机机座下放置三个地脚，用一个测力传感器代替其中一个地脚。分析了测力传感器的输出信号，静态测试测得静不平衡，对静不平衡在双校正面上进行了分离后，动态测试测得偶不平衡，对偶不平衡在双校正面上也进行了分离，该测试方法大大提高了动平衡的精度。同时，硬支承刚性转子情况下，动平衡测试的一般方法难以达到高精度动平衡的要求，而这一问题在本文得以解决
제출료일충신적동평형측시방법，즉재정밀리심궤궤좌하방치삼개지각，용일개측력전감기대체기중일개지각。분석료측력전감기적수출신호，정태측시측득정불평형，대정불평형재쌍교정면상진행료분리후，동태측시측득우불평형，대우불평형재쌍교정면상야진행료분리，해측시방법대대제고료동평형적정도。동시，경지승강성전자정황하，동평형측시적일반방법난이체도고정도동평형적요구，이저일문제재본문득이해결
The three pads under the pedestal of the precision centrifuge is used for measuring the dynamic unbalance, one of them is mounted on a force-measuring sensor. Analyzing the readout signal of the sensor, measuring the static unbalance under the static state, then the decomposition of the static unbalance on the two correction planes is separated, measuring the coupling unbalance under the dynamic state, then the decomposition of the coupling unbalance is also separated on the two correction planes. This method raises the precision of the dynamic balance greatly. In the meantime, in the case of hard-support and rigid rotor, although it is hard to satisfy the requirement for the high-precision dynamic balance to use the normal method of measuring the dynamic balance, this problem is solved in this paper.