人工晶体学报
人工晶體學報
인공정체학보
2004年
4期
596-600
,共5页
方珍意%黄朝恩%师瑞泽%潘伟
方珍意%黃朝恩%師瑞澤%潘偉
방진의%황조은%사서택%반위
Cr:iSrAlF6晶体%Bridgman法%闪光灯泵浦%斜效率
Cr:iSrAlF6晶體%Bridgman法%閃光燈泵浦%斜效率
Cr:iSrAlF6정체%Bridgman법%섬광등빙포%사효솔
Cr:iSrAlF6 crystal%Bridgman method%flashlamp-pumping%slope efficiency
本文报道了布里奇曼法生长的高品质Cr:iSrAlF6 晶体及其激光特性.采用固相氟化反应除去原料中的氧化物和水.在较小的温度梯度和较慢的生长速率下生长出的Cr:iSrAlF6晶体尺寸达到φ20mm×130mm.均匀的Cr3+掺杂浓度为1~15mol%.从XRD谱图计算出的Cr:iSAF晶体点阵参数为a=0.502nm,c=0.967nm.测试了晶体的吸收曲线,并分析了其吸收与能带结构的关系.实现了闪光灯泵浦的Cr:iSAF激光器运转,激光转换斜效率达到5.85%.
本文報道瞭佈裏奇曼法生長的高品質Cr:iSrAlF6 晶體及其激光特性.採用固相氟化反應除去原料中的氧化物和水.在較小的溫度梯度和較慢的生長速率下生長齣的Cr:iSrAlF6晶體呎吋達到φ20mm×130mm.均勻的Cr3+摻雜濃度為1~15mol%.從XRD譜圖計算齣的Cr:iSAF晶體點陣參數為a=0.502nm,c=0.967nm.測試瞭晶體的吸收麯線,併分析瞭其吸收與能帶結構的關繫.實現瞭閃光燈泵浦的Cr:iSAF激光器運轉,激光轉換斜效率達到5.85%.
본문보도료포리기만법생장적고품질Cr:iSrAlF6 정체급기격광특성.채용고상불화반응제거원료중적양화물화수.재교소적온도제도화교만적생장속솔하생장출적Cr:iSrAlF6정체척촌체도φ20mm×130mm.균균적Cr3+참잡농도위1~15mol%.종XRD보도계산출적Cr:iSAF정체점진삼수위a=0.502nm,c=0.967nm.측시료정체적흡수곡선,병분석료기흡수여능대결구적관계.실현료섬광등빙포적Cr:iSAF격광기운전,격광전환사효솔체도5.85%.
High quality Cr:iSrAlF6 (abbreviated as Cr:iSAF) crystals were grown by Bridgman method and their laser performance are reported in this paper. The starting materials were treated using a solid fluorinating agent to remove oxides and water. The size of Cr:LiSrAlF6 crystals, which were grown in a small temperature gradient at a slow growth rate, is up to 20mm in diameter and 130mm in length. 1-15mol% homogeneous Cr3+ doping concentration can be realized. From the XRD spectrum of Cr:iSAF, the lattice parameters are figured out to be a=0.502nm and c=0.967nm. The absorption spectrum of Cr:iSAF was measured and the causes bringing about the absorptions were discussed. Flashlamp-pumped Cr:iSAF laser action was realized. The slope efficiency of flashlamp-pumping is up to 5.85%.