分析测试学报
分析測試學報
분석측시학보
JOURNAL OF INSTRUMENTAL ANALYSIS
2008年
4期
381-385
,共5页
支国瑞%陈颖军%熊胜春%盛国英%傅家谟
支國瑞%陳穎軍%熊勝春%盛國英%傅傢謨
지국서%진영군%웅성춘%성국영%부가모
黑碳%热光法%温度%气溶胶
黑碳%熱光法%溫度%氣溶膠
흑탄%열광법%온도%기용효
热光法中的无氧阶段最高温度(MT)和各温度阶梯的保持时间(HT)是测定大气气溶胶中黑碳的两个关键参数.该文采集了34个气溶胶样品(含20个大气样品和14个源排放样品),并设计了6个温度程序用以系统研究MT和HT对黑碳(BC)测定的影响.实验表明,提高MT的设置,会使BC测定值降低,最高温度为850℃时的BC值为550 ℃时的62%;而有机碳(OC)发生热解(碳化)与最高温度的关系没有固定的模式,这是由样品的化学成分不同造成的.增加保持时间,使BC的测定值下降约5%,使热解率下降10%.
熱光法中的無氧階段最高溫度(MT)和各溫度階梯的保持時間(HT)是測定大氣氣溶膠中黑碳的兩箇關鍵參數.該文採集瞭34箇氣溶膠樣品(含20箇大氣樣品和14箇源排放樣品),併設計瞭6箇溫度程序用以繫統研究MT和HT對黑碳(BC)測定的影響.實驗錶明,提高MT的設置,會使BC測定值降低,最高溫度為850℃時的BC值為550 ℃時的62%;而有機碳(OC)髮生熱解(碳化)與最高溫度的關繫沒有固定的模式,這是由樣品的化學成分不同造成的.增加保持時間,使BC的測定值下降約5%,使熱解率下降10%.
열광법중적무양계단최고온도(MT)화각온도계제적보지시간(HT)시측정대기기용효중흑탄적량개관건삼수.해문채집료34개기용효양품(함20개대기양품화14개원배방양품),병설계료6개온도정서용이계통연구MT화HT대흑탄(BC)측정적영향.실험표명,제고MT적설치,회사BC측정치강저,최고온도위850℃시적BC치위550 ℃시적62%;이유궤탄(OC)발생열해(탄화)여최고온도적관계몰유고정적모식,저시유양품적화학성분불동조성적.증가보지시간,사BC적측정치하강약5%,사열해솔하강10%.