临床口腔医学杂志
臨床口腔醫學雜誌
림상구강의학잡지
JOURNAL OF CLINICAL STOMATOLOGY
2007年
10期
592-595
,共4页
苏爱军%邹敬才%姚小娣%肖杰
囌愛軍%鄒敬纔%姚小娣%肖傑
소애군%추경재%요소제%초걸
牙种植体%三维有限元分析%Von Mises应力%种植体直径%种植体长度%Ⅳ类骨质
牙種植體%三維有限元分析%Von Mises應力%種植體直徑%種植體長度%Ⅳ類骨質
아충식체%삼유유한원분석%Von Mises응력%충식체직경%충식체장도%Ⅳ류골질
目的:应用Ansys DesignXplorer模块,进行圆柱形种植体直径和长度同时连续变化时对Ⅳ类骨质的颌骨应力影响的分析.方法:建立了包含圆柱状种植体的下颌骨Ⅳ类骨质的骨块三维有限元模型,设定种植体直径(D)变化范围为3.0~5.0 mm,种植体长度(L)变化范围为6.0~16.0 mm,观察D和L变化对颌骨Von Mises应力峰值的影响.同时进行颌骨Von Mises应力峰值对变量的敏感度分析.结果:随着D和L的增加,垂直向加载时,皮质骨、松质骨的EQV应力峰值分别降低了63.9%和87.9%,颊舌向加载时,皮质骨、松质骨的EQV应力峰值分别降低了76.2%和92.7%;当D>4.0 mm L>11.0 mm时,应力峰值的响应曲线的切斜率位于-1~0之问;在垂直向加载和颊舌向加载时,变量L和D分别对皮质骨的EQV应力峰值的影响更明显.结论:颊舌向力的力学分布更易受种植体参数影响;松质骨的应力更易受种植体参数影响;种植体直径增加更有利于改善颌骨颊舌向加载下的应力分布,种植体长度的增加更有利于改善皮质骨垂直加载下的应力分布.从生物力学角度而言,对于Ⅳ类骨质在临床上选择种植体时,种植体的直径应≥4.0 mm,种植体的长度应≥11.0 mm.
目的:應用Ansys DesignXplorer模塊,進行圓柱形種植體直徑和長度同時連續變化時對Ⅳ類骨質的頜骨應力影響的分析.方法:建立瞭包含圓柱狀種植體的下頜骨Ⅳ類骨質的骨塊三維有限元模型,設定種植體直徑(D)變化範圍為3.0~5.0 mm,種植體長度(L)變化範圍為6.0~16.0 mm,觀察D和L變化對頜骨Von Mises應力峰值的影響.同時進行頜骨Von Mises應力峰值對變量的敏感度分析.結果:隨著D和L的增加,垂直嚮加載時,皮質骨、鬆質骨的EQV應力峰值分彆降低瞭63.9%和87.9%,頰舌嚮加載時,皮質骨、鬆質骨的EQV應力峰值分彆降低瞭76.2%和92.7%;噹D>4.0 mm L>11.0 mm時,應力峰值的響應麯線的切斜率位于-1~0之問;在垂直嚮加載和頰舌嚮加載時,變量L和D分彆對皮質骨的EQV應力峰值的影響更明顯.結論:頰舌嚮力的力學分佈更易受種植體參數影響;鬆質骨的應力更易受種植體參數影響;種植體直徑增加更有利于改善頜骨頰舌嚮加載下的應力分佈,種植體長度的增加更有利于改善皮質骨垂直加載下的應力分佈.從生物力學角度而言,對于Ⅳ類骨質在臨床上選擇種植體時,種植體的直徑應≥4.0 mm,種植體的長度應≥11.0 mm.
목적:응용Ansys DesignXplorer모괴,진행원주형충식체직경화장도동시련속변화시대Ⅳ류골질적합골응력영향적분석.방법:건립료포함원주상충식체적하합골Ⅳ류골질적골괴삼유유한원모형,설정충식체직경(D)변화범위위3.0~5.0 mm,충식체장도(L)변화범위위6.0~16.0 mm,관찰D화L변화대합골Von Mises응력봉치적영향.동시진행합골Von Mises응력봉치대변량적민감도분석.결과:수착D화L적증가,수직향가재시,피질골、송질골적EQV응력봉치분별강저료63.9%화87.9%,협설향가재시,피질골、송질골적EQV응력봉치분별강저료76.2%화92.7%;당D>4.0 mm L>11.0 mm시,응력봉치적향응곡선적절사솔위우-1~0지문;재수직향가재화협설향가재시,변량L화D분별대피질골적EQV응력봉치적영향경명현.결론:협설향력적역학분포경역수충식체삼수영향;송질골적응력경역수충식체삼수영향;충식체직경증가경유리우개선합골협설향가재하적응력분포,충식체장도적증가경유리우개선피질골수직가재하적응력분포.종생물역학각도이언,대우Ⅳ류골질재림상상선택충식체시,충식체적직경응≥4.0 mm,충식체적장도응≥11.0 mm.