中国化学工程学报(英文版)
中國化學工程學報(英文版)
중국화학공정학보(영문판)
CHINESE JOURNAL OF CHEMICAL ENGINEERING
2008年
3期
461-464
,共4页
赵舜华%宋锡瑾%裴宁%张景铸%刘书庆
趙舜華%宋錫瑾%裴寧%張景鑄%劉書慶
조순화%송석근%배저%장경주%류서경
N,N-dimethylformamide%polyurethane synthetic leather%absorption%recovery
A new recovery technology is developed to recycle N, N-dimethyl formamide (DMF) in waste gas from wet type polyurethane synthetic leather industry. Given that the concentration of DMF in waste gas was as low as 325.6-688.3mg·m3, it was necessary to make sure two phases contact adequately and strengthen the mass transfer by increasing contact area and enhancing the turbulence. Therefore, two-stage countercurrent absorption and two-stage fog removing system were introduced into the technology. The top section of the absorption column was filled with structured wire-ripple stainless steel packing BX500, while the lower section with sting-ripple packing CB250Y. Total height of packing material was 6m. In addition, there were both two-stage fog removing layer and high efficiency liquid distributor at the column top. All the operating parameters, including temperature, pressure, flow rate and liquid position, could be controlled by computers without manual operation, making sure the outlet gas achieved the national emission standard that the DMF concentration should be below 40mg·m3. The whole equipment could recover 237.6t of DMF each year, with the profit up to CNY 521×103.