化工学报
化工學報
화공학보
JOURNAL OF CHEMICAL INDUSY AND ENGINEERING (CHINA)
2012年
7期
2217-2223
,共7页
磷回收%鸟粪石法%耗碱量%理论计算
燐迴收%鳥糞石法%耗堿量%理論計算
린회수%조분석법%모감량%이론계산
从分析磷回收过程中的各种耗碱因素人手,推导出耗碱量的理论计算公式,计算出不同工艺条件下的理论耗碱量,并与小型套管式空气脱气填料层磷回收过程的实测值进行比较.结果表明:耗碱量的理论计算值与实验测定值的平均相对误差为18.73%,说明计算方法可用于耗碱量的工程估算;在套管式空气脱气填料层磷回收装置中,由于填料和空气对二氧化碳和氨气的脱气作用,耗碱最可节省约20%;耗碱量随出水pH值的增大而急剧增加,随废水中氨氮含量和磷初始浓度的增加都近似于线性增加,但随镁磷比的增加基本不变.因此,从节约处理成本的角度看,磷回收过程中pH值应控制在9.20~9.30,氮磷比控制在3.0~5.0,镁磷比控制在1.1~1.2为宜.磷回收过程的药剂消耗量与废水中磷的浓度和工艺条件有关,以磷初始浓度为77.5 mg·L-1,N∶ Mg∶ P=5∶ 1.2∶1,出水pH值为9.20的回收过程为例,处理每吨废水需消耗片碱0.3315 kg,成本约为0.828元,需消耗氯化镁(含6个结晶水)0.6099 kg,成本约为0.396元.因此,处理每吨废水的药剂成本约为1.224元,其中耗碱约占67.6%.
從分析燐迴收過程中的各種耗堿因素人手,推導齣耗堿量的理論計算公式,計算齣不同工藝條件下的理論耗堿量,併與小型套管式空氣脫氣填料層燐迴收過程的實測值進行比較.結果錶明:耗堿量的理論計算值與實驗測定值的平均相對誤差為18.73%,說明計算方法可用于耗堿量的工程估算;在套管式空氣脫氣填料層燐迴收裝置中,由于填料和空氣對二氧化碳和氨氣的脫氣作用,耗堿最可節省約20%;耗堿量隨齣水pH值的增大而急劇增加,隨廢水中氨氮含量和燐初始濃度的增加都近似于線性增加,但隨鎂燐比的增加基本不變.因此,從節約處理成本的角度看,燐迴收過程中pH值應控製在9.20~9.30,氮燐比控製在3.0~5.0,鎂燐比控製在1.1~1.2為宜.燐迴收過程的藥劑消耗量與廢水中燐的濃度和工藝條件有關,以燐初始濃度為77.5 mg·L-1,N∶ Mg∶ P=5∶ 1.2∶1,齣水pH值為9.20的迴收過程為例,處理每噸廢水需消耗片堿0.3315 kg,成本約為0.828元,需消耗氯化鎂(含6箇結晶水)0.6099 kg,成本約為0.396元.因此,處理每噸廢水的藥劑成本約為1.224元,其中耗堿約佔67.6%.
종분석린회수과정중적각충모감인소인수,추도출모감량적이론계산공식,계산출불동공예조건하적이론모감량,병여소형투관식공기탈기전료층린회수과정적실측치진행비교.결과표명:모감량적이론계산치여실험측정치적평균상대오차위18.73%,설명계산방법가용우모감량적공정고산;재투관식공기탈기전료층린회수장치중,유우전료화공기대이양화탄화안기적탈기작용,모감최가절성약20%;모감량수출수pH치적증대이급극증가,수폐수중안담함량화린초시농도적증가도근사우선성증가,단수미린비적증가기본불변.인차,종절약처리성본적각도간,린회수과정중pH치응공제재9.20~9.30,담린비공제재3.0~5.0,미린비공제재1.1~1.2위의.린회수과정적약제소모량여폐수중린적농도화공예조건유관,이린초시농도위77.5 mg·L-1,N∶ Mg∶ P=5∶ 1.2∶1,출수pH치위9.20적회수과정위례,처리매둔폐수수소모편감0.3315 kg,성본약위0.828원,수소모록화미(함6개결정수)0.6099 kg,성본약위0.396원.인차,처리매둔폐수적약제성본약위1.224원,기중모감약점67.6%.