材料导报
材料導報
재료도보
MATERIALS REVIEW
2009年
z2期
532-534,549
,共4页
AZ31%镁合金%退火%微观组织%晶粒度
AZ31%鎂閤金%退火%微觀組織%晶粒度
AZ31%미합금%퇴화%미관조직%정립도
AZ31%magnesium alloy%annealing%microstructure%grain size
研究了不同退火工艺下AZ31镁合金的微观组织.结果表明,退火温度在200~350℃,保温时间在30~120min时,AZ31镁合金横向和纵向显微组织变化基本一致;退火温度为300℃,保温120min后晶粒度均达到最小值,横截面最小晶粒度约为11.51μm,纵截面最小晶粒度约为12.85μm.分析了晶粒度随退火温度和保温时间的变化情况.
研究瞭不同退火工藝下AZ31鎂閤金的微觀組織.結果錶明,退火溫度在200~350℃,保溫時間在30~120min時,AZ31鎂閤金橫嚮和縱嚮顯微組織變化基本一緻;退火溫度為300℃,保溫120min後晶粒度均達到最小值,橫截麵最小晶粒度約為11.51μm,縱截麵最小晶粒度約為12.85μm.分析瞭晶粒度隨退火溫度和保溫時間的變化情況.
연구료불동퇴화공예하AZ31미합금적미관조직.결과표명,퇴화온도재200~350℃,보온시간재30~120min시,AZ31미합금횡향화종향현미조직변화기본일치;퇴화온도위300℃,보온120min후정립도균체도최소치,횡절면최소정립도약위11.51μm,종절면최소정립도약위12.85μm.분석료정립도수퇴화온도화보온시간적변화정황.
Microstructure of AZ31 magnesium alloy is studied under different annealing techniques. It is found that microstructure change of the lateral section and the longitudinal section are primarily consistent during heat treatment at 200~350℃ for 30~120min. When annealing at 300℃× 120min, the grain sizes all achieve the least values,the lateral section's is 11.51μm, the longitudinal section's is 12. 85μm. Meanwhile, the influence of annealing temperature and time on the grain growth are also analyzed.