工业水处理
工業水處理
공업수처리
INDUSTRIAL WATER TREATMENT
2014年
5期
54-56,57
,共4页
孙伟%梁光远%赵丽平%叶兆伟%殷东林
孫偉%樑光遠%趙麗平%葉兆偉%慇東林
손위%량광원%조려평%협조위%은동림
负载型催化剂Cu2O/TiO2%光催化%罗丹明B%工艺条件
負載型催化劑Cu2O/TiO2%光催化%囉丹明B%工藝條件
부재형최화제Cu2O/TiO2%광최화%라단명B%공예조건
supported catalyst Cu2O/TiO2%photocatalytic%Rhodamine B%technical conditions
采用负载型催化剂Cu2O/TiO2,以太阳光为光源,研究了其对可溶性染料罗丹明B的降解情况。主要考察了催化剂投加量,H2O2投加体积分数,溶液的酸度和反应物初始浓度等条件对罗丹明B催化降解过程的影响,从而研究催化降解的工艺条件。结果表明:Cu2O/TiO2对罗丹明B有较好的降解效果,其最佳工艺条件为:催化剂用量为1g/L,H2O2投加体积分数为1.5%,pH为5~7。此条件下,10 min就能使5 mg/L的罗丹明B溶液达到96%的降解率。
採用負載型催化劑Cu2O/TiO2,以太暘光為光源,研究瞭其對可溶性染料囉丹明B的降解情況。主要攷察瞭催化劑投加量,H2O2投加體積分數,溶液的痠度和反應物初始濃度等條件對囉丹明B催化降解過程的影響,從而研究催化降解的工藝條件。結果錶明:Cu2O/TiO2對囉丹明B有較好的降解效果,其最佳工藝條件為:催化劑用量為1g/L,H2O2投加體積分數為1.5%,pH為5~7。此條件下,10 min就能使5 mg/L的囉丹明B溶液達到96%的降解率。
채용부재형최화제Cu2O/TiO2,이태양광위광원,연구료기대가용성염료라단명B적강해정황。주요고찰료최화제투가량,H2O2투가체적분수,용액적산도화반응물초시농도등조건대라단명B최화강해과정적영향,종이연구최화강해적공예조건。결과표명:Cu2O/TiO2대라단명B유교호적강해효과,기최가공예조건위:최화제용량위1g/L,H2O2투가체적분수위1.5%,pH위5~7。차조건하,10 min취능사5 mg/L적라단명B용액체도96%적강해솔。
The photocatalytic degradation of soluble dye Rhodamine B by using Cu2O/TiO2 as supported catalyst and sunlight as light source has been studied. The effects of the conditions ,such as concentration of catalyst ,concentra-tion of H2O2,acidity of solution,initial concentration of reactants on the course of photocatalytic degradation of Rho-damine B are mainly investigated,so as to study the technological conditions of photocatalytic degradation. The re-sults show that Cu2O/TiO2 has pretty good degradation effect on Rhodamine B . The optimal conditions are as follows:concentration of catalyst is 1 g/L,concentration of H2O2 1.5%(volume ratio),pH 5-7. Under these condi-tions,it takes only 10 min for 5 mg/L of Rhodamine B solution to reach the degradation rate 96%.