原子能科学技术
原子能科學技術
원자능과학기술
ATOMIC ENERGY SCIENCE AND TECHNOLOGY
2014年
5期
801-805
,共5页
谢添舟%陈炳德%闫晓%徐建军%黄彦平%肖泽军
謝添舟%陳炳德%閆曉%徐建軍%黃彥平%肖澤軍
사첨주%진병덕%염효%서건군%황언평%초택군
摇摆运动%受力分析%矩形窄缝通道%汽泡脱离直径
搖襬運動%受力分析%矩形窄縫通道%汽泡脫離直徑
요파운동%수력분석%구형착봉통도%기포탈리직경
rolling motion%force analysis%narrow rectangular channel%bubble depar-ture diameter
在静止条件下汽泡脱离直径预测模型的基础上,引入摇摆条件引起的瞬变外力场,构建了摇摆条件下汽泡脱离直径预测模型,通过实验数据进行验证,结果符合较好。通过受力分析发现,摇摆运动引起的浮力波动必须予以考虑。模型计算发现:角位移θ=0°时,汽泡脱离直径最小;而质量流速越大,这种趋势越不明显。如果系统存在5%以上的流量波动,则其对汽泡脱离直径的影响必须加以考虑。
在靜止條件下汽泡脫離直徑預測模型的基礎上,引入搖襬條件引起的瞬變外力場,構建瞭搖襬條件下汽泡脫離直徑預測模型,通過實驗數據進行驗證,結果符閤較好。通過受力分析髮現,搖襬運動引起的浮力波動必鬚予以攷慮。模型計算髮現:角位移θ=0°時,汽泡脫離直徑最小;而質量流速越大,這種趨勢越不明顯。如果繫統存在5%以上的流量波動,則其對汽泡脫離直徑的影響必鬚加以攷慮。
재정지조건하기포탈리직경예측모형적기출상,인입요파조건인기적순변외력장,구건료요파조건하기포탈리직경예측모형,통과실험수거진행험증,결과부합교호。통과수력분석발현,요파운동인기적부력파동필수여이고필。모형계산발현:각위이θ=0°시,기포탈리직경최소;이질량류속월대,저충추세월불명현。여과계통존재5%이상적류량파동,칙기대기포탈리직경적영향필수가이고필。
Based on force balance analysis under static condition , a bubble departure model was established to predict the bubble departure size under rolling condition by considering the additional force .The proposed model agrees well with the experimental data .By force analysis it is indicated that the buoyancy fluctuation caused by rolling motion must be considered in the model .The calculation result shows that the bubble departure diameter is the minimum w hen the angular displacement is zero .T his tenden-cy is more unobvious with the increase of mass flow rate .Moreover ,if the experiment loop has more than 5% of the flow fluctuation , the influence of flow fluctuation on bubble departure diameter must be considered .