CAJ | 학술논문

采用有限元数值模拟仿真技术研究液力挤压过程中模具定径尺寸，并与实测结果相比较。结果表明：数值模拟仿真计算结果和实测结果相一致，即随着挤压比的增大，制品直径回弹量也随之增大；当制品直径尺寸精度要求大于5道时，模具设计中定径尺寸的回弹量可忽略。
채용유한원수치모의방진기술연구액력제압과정중모구정경척촌，병여실측결과상비교。결과표명：수치모의방진계산결과화실측결과상일치，즉수착제압비적증대，제품직경회탄량야수지증대；당제품직경척촌정도요구대우5도시，모구설계중정경척촌적회탄량가홀략。
The finite element numerical simulation technique was used to study the mould sizing dimension in the process of hydraulic extrusion,and the calculated results were compared with that of experimental results. The results show that the numerical simulated values are identical with experimental values. The springback values increase with the increase of extrusion ratio. The springback values of sizing dimension in die design can be disregarded if diameter dimensional accuracy of products is more than 0.01 mm.