中国中医药信息杂志
中國中醫藥信息雜誌
중국중의약신식잡지
CHINESE JOURNAL OF INFORMATION ON TRADITIONAL CHINESE MEDICINE
2013年
7期
64-65,66
,共3页
李洋%黄健%陈志峰%石思佳%毛克臣
李洋%黃健%陳誌峰%石思佳%毛剋臣
리양%황건%진지봉%석사가%모극신
清肺丸%西青果%山豆根%栀子苷%薄层色谱法%高效液相色谱法
清肺汍%西青果%山豆根%梔子苷%薄層色譜法%高效液相色譜法
청폐환%서청과%산두근%치자감%박층색보법%고효액상색보법
Qingfei pill%Fructus Termininaliae Immaturus%Radix Sophorae Subprostratae%Gardenoside%TLC%HPLC
目的建立清肺丸的质量标准。方法采用薄层色谱法对制剂中西青果、山豆根进行定性鉴别;采用高效液相色谱法对该制剂中栀子的有效成分栀子苷进行含量测定,选择Agilent Eclipse XDB-C18(150 mm×4.6 mm,5μm)色谱柱,乙腈-水(10∶90)为流动相,流速1.0 mL/min,柱温为室温,检测波长为238 nm。结果西青果、山豆根的薄层鉴别简便快速、重复性好。栀子苷在0.238~3.808μg范围呈良好的线性关系,平均回收率为97.24%,RSD=1.60%(n=6)。结论本法专属性强,重复性好,可以有效控制清肺丸的质量。
目的建立清肺汍的質量標準。方法採用薄層色譜法對製劑中西青果、山豆根進行定性鑒彆;採用高效液相色譜法對該製劑中梔子的有效成分梔子苷進行含量測定,選擇Agilent Eclipse XDB-C18(150 mm×4.6 mm,5μm)色譜柱,乙腈-水(10∶90)為流動相,流速1.0 mL/min,柱溫為室溫,檢測波長為238 nm。結果西青果、山豆根的薄層鑒彆簡便快速、重複性好。梔子苷在0.238~3.808μg範圍呈良好的線性關繫,平均迴收率為97.24%,RSD=1.60%(n=6)。結論本法專屬性彊,重複性好,可以有效控製清肺汍的質量。
목적건립청폐환적질량표준。방법채용박층색보법대제제중서청과、산두근진행정성감별;채용고효액상색보법대해제제중치자적유효성분치자감진행함량측정,선택Agilent Eclipse XDB-C18(150 mm×4.6 mm,5μm)색보주,을정-수(10∶90)위류동상,류속1.0 mL/min,주온위실온,검측파장위238 nm。결과서청과、산두근적박층감별간편쾌속、중복성호。치자감재0.238~3.808μg범위정량호적선성관계,평균회수솔위97.24%,RSD=1.60%(n=6)。결론본법전속성강,중복성호,가이유효공제청폐환적질량。
Objective To set up the quality standard of TCM preparation Qingfei pill. Methods TLC methods were used to the qualitative identification of Fructus Termininaliae Immaturus and Radix Sophorae Subprostratae in the preparation. The content of Gardenoside, the effective component of Fructus Gardeniae, was determined by HPLC method, using Agilent Eclipse XDB-C18 (150 mm×4.6 mm, 5 μm) and acetonitrile-water (10∶90) as mobile phase with flow rate at 1.0 mL/min. The column temperature was room temperature, and the detection wavelength was 238 nm. Results The TLC methods for Fructus Termininaliae Immaturus and Radix Sophorae Subprostratae identifications were simple and rapid, and showed good repetitiveness. Gardenoside presented a good linear relationship within the range of 0.238-3.808 μg, and the average recovery rate was 97.24%, RSD was 1.60% (n=6). Conclusion These methods showed strong specificity and good repetitiveness, and can be used to control the quality of the product effectively.