工程塑料应用
工程塑料應用
공정소료응용
ENGINEERING PLASTICS APPLICATION
2014年
7期
53-55,56
,共4页
曾巍%周细枝%钱应平%刘丹%程成
曾巍%週細枝%錢應平%劉丹%程成
증외%주세지%전응평%류단%정성
极差法%注塑工艺参数%正交实验%翘曲
極差法%註塑工藝參數%正交實驗%翹麯
겁차법%주소공예삼수%정교실험%교곡
range method%injection molding process parameter%orthogonal experiment%warpage
以空调转接头塑料制品为例,结合正交实验,以翘曲量为评价指标,研究模具温度、熔体温度、保压压力、保压时间等注塑工艺参数对制品翘曲变形的影响,运用极差法对正交实验结果进行分析,得到各工艺参数对翘曲变形影响的主次程度,最终获得最优工艺参数组合,即模具温度60℃,熔体温度240℃,保压压力35 MPa,保压时间15 s,在此工艺组合下的翘曲量为0.0921 mm。
以空調轉接頭塑料製品為例,結閤正交實驗,以翹麯量為評價指標,研究模具溫度、鎔體溫度、保壓壓力、保壓時間等註塑工藝參數對製品翹麯變形的影響,運用極差法對正交實驗結果進行分析,得到各工藝參數對翹麯變形影響的主次程度,最終穫得最優工藝參數組閤,即模具溫度60℃,鎔體溫度240℃,保壓壓力35 MPa,保壓時間15 s,在此工藝組閤下的翹麯量為0.0921 mm。
이공조전접두소료제품위례,결합정교실험,이교곡량위평개지표,연구모구온도、용체온도、보압압력、보압시간등주소공예삼수대제품교곡변형적영향,운용겁차법대정교실험결과진행분석,득도각공예삼수대교곡변형영향적주차정도,최종획득최우공예삼수조합,즉모구온도60℃,용체온도240℃,보압압력35 MPa,보압시간15 s,재차공예조합하적교곡량위0.0921 mm。
Taking air conditioning connector plastic products as an example and the warpage value as evaluation index, combined with orthogonal experiment,the effects of injection molding process parameters such as mold temperature,melt temperature,holding pressure,holding time on the warpage of the products were studied. Orthogonal experimental results were analyzed by the range method and the primary and secondary effects of the process parameters on the warpage were gained. Finally the optimal combination of the process parameters is obtained,which is that the mold temperature is 60℃,the melting temperature is 240℃,the holding pressure is 35 MPa and the holding time is 15 s. The warpage value under the optimal combination of the process parameters is 0.0921 mm.