CAJ | 학술논문

采用热分析和流变分析技术，系统地分析了耐烧蚀混合树脂体系---聚硅氮烷与烯丙基酚醛(PSN/AP)树脂体系的固化特性与化学流变特性. DSC 分析表明，该树脂体系的两组分间存在固化反应的同步性，表现为单一固化放热峰，外推起始和终止反应温度分别为168和338℃.该混合树脂体系的化学流变特性无法用单一模型来描述，分析表明，当温度低于和高于起始反应温度时，可分别采用工程模型方程和阿累尼乌斯关系方程拟合.模型拟合数据与实测数据具有较好的一致性，针对 VARTM 成型技术，最适宜的注射温度在125℃左右.
채용열분석화류변분석기술，계통지분석료내소식혼합수지체계---취규담완여희병기분철(PSN/AP)수지체계적고화특성여화학류변특성. DSC 분석표명，해수지체계적량조분간존재고화반응적동보성，표현위단일고화방열봉，외추기시화종지반응온도분별위168화338℃.해혼합수지체계적화학류변특성무법용단일모형래묘술，분석표명，당온도저우화고우기시반응온도시，가분별채용공정모형방정화아루니오사관계방정의합.모형의합수거여실측수거구유교호적일치성，침대 VARTM 성형기술，최괄의적주사온도재125℃좌우.
The curing and rheological behaviors of the ablative resin-the PSN/AP resin blends were studied through thermal and rheological analysis techniques.The DSC analysis indicated that the synchronization reac-tion existed between the two components in the resin system confirmed by a single exothermic peak in the cu-ring curves;and the starting and final curing temperature were 1 68 and 338 ℃ determined through the extrapo-lation method,respectively.The chemical rheological behaviors of the resin blends couldn’t be described by a single viscosity model:the engineering and the Arrhenius viscosity equation were established separately when the temperature was below or higher than the starting curing temperature.The model values were in good agreement with the experimental results and the optimal injection temperature was at about 125 ℃.