辽宁石油化工大学学报
遼寧石油化工大學學報
료녕석유화공대학학보
JOURNAL OF LIAONING UNIVERSITY OF PETROLEUM & CHEMICAL TECHNOLOGY
2014年
2期
17-20
,共4页
柴阳%刘姝%王钧%娄庆海%王小飞%于廷云
柴暘%劉姝%王鈞%婁慶海%王小飛%于廷雲
시양%류주%왕균%루경해%왕소비%우정운
微湿气体%FCC汽油%分子筛%吸附剂%脱硫
微濕氣體%FCC汽油%分子篩%吸附劑%脫硫
미습기체%FCC기유%분자사%흡부제%탈류
Moist gas%FCC gasoline%Catalyst%Adsorbent%Desulfurization
以 Y型分子筛为载体、不同质量分数的硝酸镍为活性组分,采用浸渍法制得一种 FCC汽油吸附脱硫吸附剂。在不同温度下用微湿气体法处理载体,得到比表面积为780 m2/g、孔径为0.742 nm 且孔结构较为均匀的吸附剂。利用微型反应装置,在不同空速下,考察吸附剂吸附脱硫的活性。结果表明:硝酸镍质量分数为15%,对载体的处理温度为950℃,空速为0.5 h-1时,与未经处理的吸附剂相比,微湿气体处理的吸附剂具有较好的吸附活性,吸附脱硫率达到89%。
以 Y型分子篩為載體、不同質量分數的硝痠鎳為活性組分,採用浸漬法製得一種 FCC汽油吸附脫硫吸附劑。在不同溫度下用微濕氣體法處理載體,得到比錶麵積為780 m2/g、孔徑為0.742 nm 且孔結構較為均勻的吸附劑。利用微型反應裝置,在不同空速下,攷察吸附劑吸附脫硫的活性。結果錶明:硝痠鎳質量分數為15%,對載體的處理溫度為950℃,空速為0.5 h-1時,與未經處理的吸附劑相比,微濕氣體處理的吸附劑具有較好的吸附活性,吸附脫硫率達到89%。
이 Y형분자사위재체、불동질량분수적초산얼위활성조분,채용침지법제득일충 FCC기유흡부탈류흡부제。재불동온도하용미습기체법처리재체,득도비표면적위780 m2/g、공경위0.742 nm 차공결구교위균균적흡부제。이용미형반응장치,재불동공속하,고찰흡부제흡부탈류적활성。결과표명:초산얼질량분수위15%,대재체적처리온도위950℃,공속위0.5 h-1시,여미경처리적흡부제상비,미습기체처리적흡부제구유교호적흡부활성,흡부탈류솔체도89%。
With the Y-zeolite as a carrier,nickel nitrate as the active component,a sorbent for FCC gasoline adsorption desulfurization is prepared.Treated with moist gas under the different temperature,the prepared adsorbent has a specific surface area 780 m2/g and aperture about 0.742 nm.The prepared sorbent are used for FCC gasoline desulfurization in the micro-reactor,the effects of space velocity on adsorbent activity of adsorption desulfurization are investigated.The results show that the adsorbent has good activity and its adsorption desulfurization rate reaches 89% when the active component content in the weight of Y-zeolite is 15% and treated at 950 ℃,and space velocity is 0.5h-1.