CAJ | 학술논문

本文在分析了IEC有关插头插座以及转换器标准的尺寸要求的基础上，根据我国国标中有关单相尺寸要求的情况，提出我国应制定圆销插头或取消插座中有关圆形插孔的尺寸型式、参数和尺寸要求，应制定0类设备插头或取消国标的尺寸要求中有关0类设备插头的描述，建议采用能重合单相两极带接地的插头插座型式代替单相两极的插头插座，并且为了适应目前转换器的发展需要，提出对转换器的安全要求应仅限于除尺寸外其他适用的所有安全要求。
본문재분석료IEC유관삽두삽좌이급전환기표준적척촌요구적기출상，근거아국국표중유관단상척촌요구적정황，제출아국응제정원소삽두혹취소삽좌중유관원형삽공적척촌형식、삼수화척촌요구，응제정0류설비삽두혹취소국표적척촌요구중유관0류설비삽두적묘술，건의채용능중합단상량겁대접지적삽두삽좌형식대체단상량겁적삽두삽좌，병차위료괄응목전전환기적발전수요，제출대전환기적안전요구응부한우제척촌외기타괄용적소유안전요구。
Based on the analysis of dimension requirements of the IEC standards for plug, socket-outlet and converter, and according to the single-phase dimension requirements of China’s national standard, the paper proposes that China should draw up requirements of types, basic parameters and dimension of circular plugs or cancellrequirement of types, basic parameters and dimension of round jack on socket-outlet, and the dimension requirements of 0 type equipment or cancelldescription about 0 type equipment in the GB standard. The paper recommends using two pins of single-phase with ground poles instead of the single-phase no ground poles, and proposed safety requirements for the converter shall be limited to other safety requirements except dimension.