后勤工程学院学报
後勤工程學院學報
후근공정학원학보
JOURNAL OF LOGISTICAL ENGINEERING UNIVERSITY
2014年
1期
47-51,78
,共6页
交流杂散电流%腐蚀试验%腐蚀速率%阴极保护
交流雜散電流%腐蝕試驗%腐蝕速率%陰極保護
교류잡산전류%부식시험%부식속솔%음겁보호
AC stray current%corrosion test%corrosion rate%cathodic protection
为探究交流杂散电流的影响因素及其对阴极保护系统的影响,搭建交流干扰腐蚀实验平台研究了土壤电阻率、干扰电压大小、涂层电阻率和通断时间比对交流杂散电流密度的影响;采用腐蚀试片失重法研究了交流杂散电流密度对腐蚀速率的影响以及阴极保护电位分别为-850 mV和-1000 mV时对阴极保护系统的影响。实验结果表明:土壤电阻率、干扰电压大小、涂层电阻率和通断时间比对交流杂散电流密度具有较为显著的影响;阴极保护电位为-1000 mV时,即使交流电流密度为20 mA/cm2,腐蚀试片也能得到有效保护。因此,埋地管道应采用绝缘性能好的防腐涂层,规划合理的铺设路线,并在运行过程中采取强制电流阴极保护系统,设置合理的阴极保护电位。
為探究交流雜散電流的影響因素及其對陰極保護繫統的影響,搭建交流榦擾腐蝕實驗平檯研究瞭土壤電阻率、榦擾電壓大小、塗層電阻率和通斷時間比對交流雜散電流密度的影響;採用腐蝕試片失重法研究瞭交流雜散電流密度對腐蝕速率的影響以及陰極保護電位分彆為-850 mV和-1000 mV時對陰極保護繫統的影響。實驗結果錶明:土壤電阻率、榦擾電壓大小、塗層電阻率和通斷時間比對交流雜散電流密度具有較為顯著的影響;陰極保護電位為-1000 mV時,即使交流電流密度為20 mA/cm2,腐蝕試片也能得到有效保護。因此,埋地管道應採用絕緣性能好的防腐塗層,規劃閤理的鋪設路線,併在運行過程中採取彊製電流陰極保護繫統,設置閤理的陰極保護電位。
위탐구교류잡산전류적영향인소급기대음겁보호계통적영향,탑건교류간우부식실험평태연구료토양전조솔、간우전압대소、도층전조솔화통단시간비대교류잡산전류밀도적영향;채용부식시편실중법연구료교류잡산전류밀도대부식속솔적영향이급음겁보호전위분별위-850 mV화-1000 mV시대음겁보호계통적영향。실험결과표명:토양전조솔、간우전압대소、도층전조솔화통단시간비대교류잡산전류밀도구유교위현저적영향;음겁보호전위위-1000 mV시,즉사교류전류밀도위20 mA/cm2,부식시편야능득도유효보호。인차,매지관도응채용절연성능호적방부도층,규화합리적포설로선,병재운행과정중채취강제전류음겁보호계통,설치합리적음겁보호전위。
In order to study the influence factors of AC stray current and the impact of AC stray current on the cathodic protec-tion system,an AC interference corrosion experimental platform is built to study the influence of soil resistivity,the interfering volt-age,the coating resistivity and the on-off time ratio on AC stray current. Corrosion specimens weightlessness method is used to study the influence of AC stray current density on corrosion rate and the influence of AC stray current density on cathodic protection sys-tem when the cathodic protection potential is-850 mV and-1 000 mV respectively. The experimental results show that the soil re-sistivity,the interfering voltage,the coating resistivity and the on-off time ratio of AC stray current density have a significant effect on the AC stray current density. When the cathodic protection potential is-1 000 mV,corrosion specimens can be effectively pro-tected even if the AC current density reaches 20 mA/cm2. Therefore,the appropriate anticorrosive coating should be applied to bur-ied pipeline. The reasonable route should be planed. Meanwhile,the compulsory current system should be adopted and the reason-able cathodic protection potential should be set properly during the operation of pipelines.