CAJ | 학술논문

为有效提高穴盘苗向立柱自动移栽的作业效率，以自主开发的螺旋式栽培立柱及其配套移栽机器人系统为对象，进行了无碰撞最短路径设计，进而对不同取苗-栽植方案的路径长度差异及其影响因素进行了分析。研究表明，面向立柱移栽时，单穴盘对1 m立柱移栽的累计路径长度差异在25%以上。取苗顺序对路径长度具有重要影响，其中“让苗”现象是造成累计路径长度差异的主要因素。立柱栽植顺序对路径长度的影响随立柱高度增加而显著增大，对3 m立柱移栽时16类取苗方案的自上至下植苗平均累计路径长度比自下至上高9.83%。稳定最优方案分别为最近相邻法和近端开始同向逐行或逐列取苗、自下至上栽植方案。研究成果对实现高效的立柱自动移栽具有积极意义。
위유효제고혈반묘향립주자동이재적작업효솔，이자주개발적라선식재배립주급기배투이재궤기인계통위대상，진행료무팽당최단로경설계，진이대불동취묘-재식방안적로경장도차이급기영향인소진행료분석。연구표명，면향립주이재시，단혈반대1 m립주이재적루계로경장도차이재25%이상。취묘순서대로경장도구유중요영향，기중“양묘”현상시조성루계로경장도차이적주요인소。립주재식순서대로경장도적영향수립주고도증가이현저증대，대3 m립주이재시16류취묘방안적자상지하식묘평균루계로경장도비자하지상고9.83%。은정최우방안분별위최근상린법화근단개시동향축행혹축렬취묘、자하지상재식방안。연구성과대실현고효적립주자동이재구유적겁의의。
Column cultivation is a promising high-yield mode in protected agriculture which has been studied and developed for several years. However, its extreme difficulty of manual management has hindered its popularization and application. As a result, an automatic operation of seedling transplanting to column was put forward. A new-type spiral cultivation column and matched seedling transplanting robot that was composed of rail-mounted autonomous vehicle, slide-arm type manipulator, double-needle electromagnet-driven end-effector, and a turning seedling supply device was developed. In view of the frequently repetitive operation of robotic seedling transplanting with changing starting and ending points of routes, the optimal design of a pick-plant sequence and non-collision shortest routing are essential to improving the success rate and efficiency. In robotic seedling transplanting, the route of a manipulator's ending is usually composed of picking an up-down route, a plant up-down route, and a transport route from pick top-point to plant top-point. For column cultivation, the transport route is quite different with regular robotic transplanting in view of its three-dimensional feature. So in this paper, a design of the shortest non-collision route was performed first for robotic seedling transplanting to spiral cultivation columns. In optimal route design, different principles were adopted for different relationships between the height of the plug position and height of the plant position in a column, together with the issue of seedling avoidance since a pick up-down route had to be extended to avoid a collision with other seedlings. And then the shortest non-collision route length of thirty-two different sequential pick-plant plans and a plan by a nearest neighbor algorithm were compared. Sequential pick plans were divided into S-shape and equidirectional seedling pick sequences that had different starting points, while sequential plant plans were divided into bottom-to-top and top-to-bottom sequences. The study indicated that the difference between the maximal and the minimal accumulated route length was more than 25%when seedlings of a total plug were transplanted to several one-meter-high columns. The pick sequence had an important effect on route length, which may mainly be attributed to the necessary of seedling avoidance. The computed results indicated that thirty-two plans were distributed in three areas, and each area had similar seedling avoidance times and accumulated route lengths. The plan by the nearest neighbor algorithm and equidirectional sequential pick with bottom-to-top plant had a stable value of route length when one plug of seedlings was transplanted to multiple columns. The effect of plant sequence on route length obviously rose with the increase of column height, and the average accumulated route length of 16 pick sequences when transplanting to three-meter-high column from top to bottom was 9.83%higher than transplanting from bottom to top. We found that the steady optimal schemes were pick-plant sequence searched by nearest neighbor algorithm and equidirectional sequential pick with bottom-to-top plant. To apply in control of robotic seedling transplanting, a plan of equidirectional sequential pick with bottom-to-top plant may be selected in priority in view of its obvious advantage of real-time rapid execution.