材料研究与应用
材料研究與應用
재료연구여응용
MATERIALS RESEARCH AND APPLICATION
2014年
3期
145-149
,共5页
于方%殷素红%王果%张二猛
于方%慇素紅%王果%張二猛
우방%은소홍%왕과%장이맹
泡沫混凝土%抗压强度%吸水率%增稠剂%增强纤维
泡沫混凝土%抗壓彊度%吸水率%增稠劑%增彊纖維
포말혼응토%항압강도%흡수솔%증주제%증강섬유
foamed concrete%compressive strength%water absorption%thickener%reinforced fiber
主要研究了水胶比、发泡剂稀释倍率、增稠剂种类和掺量、增强纤维种类和掺量等对泡沫混凝土性能的影响,以期找到改善泡沫混凝土性能的措施.研究结果表明:在水胶比为0.3及发泡剂稀释倍率为1∶70条件下,配制干密度为400 kg/m3的泡沫混凝土较为适宜,其抗压强度可达0.88 M Pa;掺入占胶凝材料质量0.1%的纤维素醚或占浆体体积0.1%的玻璃纤维,虽然泡沫混凝土的干密度有所增大,但其吸水率降低,抗压强度明显提高,分别可达1.34 M Pa和1.48 M Pa .
主要研究瞭水膠比、髮泡劑稀釋倍率、增稠劑種類和摻量、增彊纖維種類和摻量等對泡沫混凝土性能的影響,以期找到改善泡沫混凝土性能的措施.研究結果錶明:在水膠比為0.3及髮泡劑稀釋倍率為1∶70條件下,配製榦密度為400 kg/m3的泡沫混凝土較為適宜,其抗壓彊度可達0.88 M Pa;摻入佔膠凝材料質量0.1%的纖維素醚或佔漿體體積0.1%的玻璃纖維,雖然泡沫混凝土的榦密度有所增大,但其吸水率降低,抗壓彊度明顯提高,分彆可達1.34 M Pa和1.48 M Pa .
주요연구료수효비、발포제희석배솔、증주제충류화참량、증강섬유충류화참량등대포말혼응토성능적영향,이기조도개선포말혼응토성능적조시.연구결과표명:재수효비위0.3급발포제희석배솔위1∶70조건하,배제간밀도위400 kg/m3적포말혼응토교위괄의,기항압강도가체0.88 M Pa;참입점효응재료질량0.1%적섬유소미혹점장체체적0.1%적파리섬유,수연포말혼응토적간밀도유소증대,단기흡수솔강저,항압강도명현제고,분별가체1.34 M Pa화1.48 M Pa .
Lots of aspects affect the properties of foamed concrete ,for the seek of improvinge the properties of foamed concrete ,water to binder ratio ,dilution ratio of foaming agent were investigated ,as well as the types and dosage of thickening agent and reinforcedenhanced fiber .The results show that when the water to binder ratio of 0 .3 and foaming agent dilution ratio of 1 :70 conditions ,foamed concrete of dry density is 400 kg/m3 would acquire the best properties .Its compressive strength can be achieved up to 0 .88MPa ;Mixed with 0 .1% cellulose ether by mass of the cementations material or 0 .1% glass fiber by volume of the paste ,the dry density of foamed concrete increased ,while its water absorption is lower ,the compres-sive strength increased significantly ,up to 1 .34 MPa and 1 .48 MPa ,respectively .