红外与激光工程
紅外與激光工程
홍외여격광공정
INFRARED AND LASER ENGINEERING
2014年
5期
1511-1516
,共6页
李冰%赵跃进%张超%郭小虎%张镜水%孔令琴
李冰%趙躍進%張超%郭小虎%張鏡水%孔令琴
리빙%조약진%장초%곽소호%장경수%공령금
光学设计%激光告警%柱透镜%线聚焦%光线追迹
光學設計%激光告警%柱透鏡%線聚焦%光線追跡
광학설계%격광고경%주투경%선취초%광선추적
optical design%laser warning%cylindrical lens%linear focusing%ray tracing
针对非成像式激光告警系统的工作特点与要求,提出并设计了一种双片式柱透镜光学结构。对柱面光线追迹以及柱透镜成像进行了深入分析,提出了一种新型像差优化方法,使其在子午方向各个视场的调制传递函数得到最大幅度的优化。此光学系统由两片硒化锌柱透镜组成,满足了1.0~4.0μm工作波长范围,并且克服了传统单片式柱透镜和柱面反射镜视场通常小于1o且聚焦线斑不理想的缺点,其视场达到20o,在7 lp/mm空间分辨率条件下,边缘视场子午方向的调制传递函数值优于0.7,达到了非成像式激光告警系统的要求。
針對非成像式激光告警繫統的工作特點與要求,提齣併設計瞭一種雙片式柱透鏡光學結構。對柱麵光線追跡以及柱透鏡成像進行瞭深入分析,提齣瞭一種新型像差優化方法,使其在子午方嚮各箇視場的調製傳遞函數得到最大幅度的優化。此光學繫統由兩片硒化鋅柱透鏡組成,滿足瞭1.0~4.0μm工作波長範圍,併且剋服瞭傳統單片式柱透鏡和柱麵反射鏡視場通常小于1o且聚焦線斑不理想的缺點,其視場達到20o,在7 lp/mm空間分辨率條件下,邊緣視場子午方嚮的調製傳遞函數值優于0.7,達到瞭非成像式激光告警繫統的要求。
침대비성상식격광고경계통적공작특점여요구,제출병설계료일충쌍편식주투경광학결구。대주면광선추적이급주투경성상진행료심입분석,제출료일충신형상차우화방법,사기재자오방향각개시장적조제전체함수득도최대폭도적우화。차광학계통유량편서화자주투경조성,만족료1.0~4.0μm공작파장범위,병차극복료전통단편식주투경화주면반사경시장통상소우1o차취초선반불이상적결점,기시장체도20o,재7 lp/mm공간분변솔조건하,변연시장자오방향적조제전체함수치우우0.7,체도료비성상식격광고경계통적요구。
Based on the characteristic of laser warning system with non-imaging imaging mode, a double cylindrical lens system was presented. A new optimization method, based on the ray tracing of cylindrical lens, was introduced in this paper. Traditional single-cylindrical lens and cylindrical reflector systems were limited by FOV, less than 1o, and low-quality line spot. This optical system, composed by two ZnSe cylindrical lenses, meets the operating wavelength of 1.0- 4.0 μm and achieves a 20o FOV and the modulation transfer function(MTF) is better than 0.7 at 7 lp/mm on the edge of FOV. This optical system achieves the requirement of laser warning system with non-imaging mode.