红外与激光工程
紅外與激光工程
홍외여격광공정
INFRARED AND LASER ENGINEERING
2014年
2期
605-609
,共5页
杨承燕%王玺堂%马妍%王周福%刘浩%秦梦黎
楊承燕%王璽堂%馬妍%王週福%劉浩%秦夢黎
양승연%왕새당%마연%왕주복%류호%진몽려
YMnO3%微波辅助%溶胶-凝胶法%纳米粉体
YMnO3%微波輔助%溶膠-凝膠法%納米粉體
YMnO3%미파보조%용효-응효법%납미분체
YMnO3%microwave-assisted%sol-gel%nano-powders
采用微波辅助溶胶-凝胶法制备了YMnO3纳米粉体,利用FTIR和TG-DSC对凝胶的组成及热分解过程进行分析,并通过XRD、FSEM、TEM和磁性能测试对制得的纳米粉体进行表征。结果表明:与传统的溶胶-凝胶法相比,该研究中采用的微波辅助溶胶-凝胶法可以在较短的制备时间内、较低的煅烧温度下得到单相的YMnO3粉体,且粉体颗粒细小,尺寸分布较均匀,平均粒径小于100 nm。磁性能研究结果表明制得的YMnO3纳米粉体在室温下表现为顺磁性特征。
採用微波輔助溶膠-凝膠法製備瞭YMnO3納米粉體,利用FTIR和TG-DSC對凝膠的組成及熱分解過程進行分析,併通過XRD、FSEM、TEM和磁性能測試對製得的納米粉體進行錶徵。結果錶明:與傳統的溶膠-凝膠法相比,該研究中採用的微波輔助溶膠-凝膠法可以在較短的製備時間內、較低的煅燒溫度下得到單相的YMnO3粉體,且粉體顆粒細小,呎吋分佈較均勻,平均粒徑小于100 nm。磁性能研究結果錶明製得的YMnO3納米粉體在室溫下錶現為順磁性特徵。
채용미파보조용효-응효법제비료YMnO3납미분체,이용FTIR화TG-DSC대응효적조성급열분해과정진행분석,병통과XRD、FSEM、TEM화자성능측시대제득적납미분체진행표정。결과표명:여전통적용효-응효법상비,해연구중채용적미파보조용효-응효법가이재교단적제비시간내、교저적단소온도하득도단상적YMnO3분체,차분체과립세소,척촌분포교균균,평균립경소우100 nm。자성능연구결과표명제득적YMnO3납미분체재실온하표현위순자성특정。
YMnO3 nano-powders were synthesized by microwave-assisted sol-gel method. The composition and the thermo-decomposing process of the gel were studied by means of IR spectrum and TG-DSC analysis. The phase constitutution and particle morphology of the YMnO3 powders were characterized by XRD, FSEM and TEM. The magnetic properties of YMnO3 nano-powders were also studied. The results show that, by using microwave-assisted sol-gel method, nano-sized YMnO3 powders can be synthsized under lower calcined temperature in relatively shorter time compared with the traditional sol-gel method. The YMnO3 powders prepared by the microwave-assisted method have a uniform particle size smaller than 100 nm. The magnetic hysteresis loop result shows that YMnO3 nano-powders exhibit paramagnetic characteristic at room temperature.