中国环境科学
中國環境科學
중국배경과학
CHINA ENVIRONMENTAL SCIENCE
2014年
4期
930-934
,共5页
欧阳云%席劲瑛%王智超%胡洪营
歐暘雲%席勁瑛%王智超%鬍洪營
구양운%석경영%왕지초%호홍영
污泥%硫化物%吸附特性%污水处理厂
汙泥%硫化物%吸附特性%汙水處理廠
오니%류화물%흡부특성%오수처리엄
activated sludge%sulfides%adsorption characteristics%wastewater treatment plants
为研究城市污水厂污泥对水中硫化物的吸附特性,从3座城市污水处理厂采集回流污泥,考察了硫化物浓度、温度、pH值和其他离子对污泥吸附硫化物的影响.结果表明,污水厂回流污泥对硫化物的吸附等温线可以用 Langmuir 方程很好地描述,其最大硫化物吸附量为15~27mg/g-干污泥.在温度为5~35℃条件下,吸附量随温度上升而增加,表明该吸附为吸热过程.pH值在2~7范围内,pH值对污泥吸附硫化物的影响不大,当pH值低于2时,污泥对硫化物的吸附量随pH降低显著减小.硫化物可能以离子形式被污泥吸附,该过程为化学吸附过程.水中存在0~25mg/L Cl-或0~12mg/L SO2-4不影响污泥对硫化物的吸附量.
為研究城市汙水廠汙泥對水中硫化物的吸附特性,從3座城市汙水處理廠採集迴流汙泥,攷察瞭硫化物濃度、溫度、pH值和其他離子對汙泥吸附硫化物的影響.結果錶明,汙水廠迴流汙泥對硫化物的吸附等溫線可以用 Langmuir 方程很好地描述,其最大硫化物吸附量為15~27mg/g-榦汙泥.在溫度為5~35℃條件下,吸附量隨溫度上升而增加,錶明該吸附為吸熱過程.pH值在2~7範圍內,pH值對汙泥吸附硫化物的影響不大,噹pH值低于2時,汙泥對硫化物的吸附量隨pH降低顯著減小.硫化物可能以離子形式被汙泥吸附,該過程為化學吸附過程.水中存在0~25mg/L Cl-或0~12mg/L SO2-4不影響汙泥對硫化物的吸附量.
위연구성시오수엄오니대수중류화물적흡부특성,종3좌성시오수처리엄채집회류오니,고찰료류화물농도、온도、pH치화기타리자대오니흡부류화물적영향.결과표명,오수엄회류오니대류화물적흡부등온선가이용 Langmuir 방정흔호지묘술,기최대류화물흡부량위15~27mg/g-간오니.재온도위5~35℃조건하,흡부량수온도상승이증가,표명해흡부위흡열과정.pH치재2~7범위내,pH치대오니흡부류화물적영향불대,당pH치저우2시,오니대류화물적흡부량수pH강저현저감소.류화물가능이리자형식피오니흡부,해과정위화학흡부과정.수중존재0~25mg/L Cl-혹0~12mg/L SO2-4불영향오니대류화물적흡부량.
In this study, activated sludge samples were collected from 3municipal wastewater treatment plants (WWTP) and the performance and impacting factors of sulfides adsorption onto the activated sludge were investigated. The impacting factors include sulfides concentration, temperature, pH and other anions. Adsorption isotherm of sulfide onto the activated sludge can be well described by Langmuir equation. The maximum sulfide adsorption capacity was 15~27mg/g-dry sludge. At the temperatures ranging from 5to 35℃, adsorption capacity increased by the rise in temperature and this implies the sulfides adsorption was an endothermic process. The pH value had little effect on the adsorption capacity from 2to 7. But the sulfides adsorption capacity decreased significantly when pH was lower than 2. Sulfides were adsorbed by activated sludge as anions (HS- and S2-) and it was a chemical adsorption process. Cl- ranging from 0 to 25mg/LorSO2- 4 ranging from 0 to 12mg/L did not affect the sulfides adsorption capacity.