火工品
火工品
화공품
INITIATORS & PYROTECHNICS
2014年
3期
1-5
,共5页
刘国生%关华%宋东明%侯伟%张祺祺
劉國生%關華%宋東明%侯偉%張祺祺
류국생%관화%송동명%후위%장기기
烟幕%撞击流%气动喷撒%成烟特性%高速摄影
煙幕%撞擊流%氣動噴撒%成煙特性%高速攝影
연막%당격류%기동분살%성연특성%고속섭영
Smokescreen%Impact streams%Pneumatic spray%Forming smokescreen characteristic%High speed photography
为改善气动喷撒时烟幕的分散效果,采用自行设计的气动喷撒装置,对铜粉基烟幕粒子的撞击成烟特性进行了实验研究。结果表明,相对于单喷嘴,双喷嘴喷撒时烟幕平均扩散速度降低了39%,烟幕扩张角增大了160%;当喷嘴间角度为150°、120°、90°和60°时,对应的烟幕平均扩散速度分别为0.5m/s、0.8m/s、1.1m/s和1.6m/s,烟幕扩张角为60.2°、57.4°、45.8°和44.3°。随着喷嘴间角度的减小,烟幕平均扩散速度逐渐增大,烟幕扩张角逐渐减小;持续喷撒一定时间,烟幕最大面密度随喷嘴间角度的减小逐渐减小,烟幕遮蔽效能变差。
為改善氣動噴撒時煙幕的分散效果,採用自行設計的氣動噴撒裝置,對銅粉基煙幕粒子的撞擊成煙特性進行瞭實驗研究。結果錶明,相對于單噴嘴,雙噴嘴噴撒時煙幕平均擴散速度降低瞭39%,煙幕擴張角增大瞭160%;噹噴嘴間角度為150°、120°、90°和60°時,對應的煙幕平均擴散速度分彆為0.5m/s、0.8m/s、1.1m/s和1.6m/s,煙幕擴張角為60.2°、57.4°、45.8°和44.3°。隨著噴嘴間角度的減小,煙幕平均擴散速度逐漸增大,煙幕擴張角逐漸減小;持續噴撒一定時間,煙幕最大麵密度隨噴嘴間角度的減小逐漸減小,煙幕遮蔽效能變差。
위개선기동분살시연막적분산효과,채용자행설계적기동분살장치,대동분기연막입자적당격성연특성진행료실험연구。결과표명,상대우단분취,쌍분취분살시연막평균확산속도강저료39%,연막확장각증대료160%;당분취간각도위150°、120°、90°화60°시,대응적연막평균확산속도분별위0.5m/s、0.8m/s、1.1m/s화1.6m/s,연막확장각위60.2°、57.4°、45.8°화44.3°。수착분취간각도적감소,연막평균확산속도축점증대,연막확장각축점감소;지속분살일정시간,연막최대면밀도수분취간각도적감소축점감소,연막차폐효능변차。
In order to improve dispersion effect of smokescreen sprayed by nozzle,the characteristics of copper-based smokescreen was experimental studied, by a novel class of self-designed pneumatic actuator. Compared with traditional single-nozzle, the average diffusion velocity of smokescreen (ADVS) was reduced by 39%,as well as the expansion angle of smokescreen (EAS) was increased by 160%, by use of dual-nozzle system. While the angle between nozzles were 150°, 120°, 90° and 60°, the corresponding ADVS were 0.5m/s, 0.8 m/s, 1.1 m/s and 1.6 m/s, and corresponding EAS were 60.2°, 57.4°, 45.8° and 44.3°, respectively. Obviously, the decrease of angle between nozzles led to increase of ADVS and gradual reduce of EAS, the maximum areal density of smokescreen declined as the decreasing of the angle between nozzles within a period of spraying time, and the extinction ability get worse gradually.