西南交通大学学报
西南交通大學學報
서남교통대학학보
JOURNAL OF SOUTHWEST JIAOTONG UNIVERSITY
2014年
4期
649-655
,共7页
谢铠泽%王平%徐井芒%徐浩
謝鎧澤%王平%徐井芒%徐浩
사개택%왕평%서정망%서호
单元板式无砟轨道%无缝线路%限值%适应性
單元闆式無砟軌道%無縫線路%限值%適應性
단원판식무사궤도%무봉선로%한치%괄응성
unit slab non-ballast track%continuous welded rail%limit value%adaptability
为研究适应连续梁桥上单元板式无砟轨道的最大温度跨度,采用有限元方法建立了线-板-桥-墩一体化计算模型,分析了在不同轨温变化幅度下,桥梁伸缩、墩顶水平位移及列车制动荷载对桥上单元板式无砟轨道无缝线路温度跨度限值的影响.研究结果表明:温度跨度限值随轨温变化幅度的增加而降低;为保证钢轨强度、横向压弯变形及钢轨与轨道板相对位移等满足要求,当考虑桥梁伸缩时,以轨温变化40℃为例,其适应的温度跨度限值为271 m;随着墩顶水平位移的增加,桥梁温度跨度限值显著降低,当墩顶位移为30 mm时,温度跨度为237 m,当高墩桥梁墩顶位移超过30 mm时,应结合实际墩顶位移计算温度跨度限值;制动荷载下线路坡度对温度跨度限值影响较小,当线路坡度为20‰时,桥梁温度跨度限值为258 m.
為研究適應連續樑橋上單元闆式無砟軌道的最大溫度跨度,採用有限元方法建立瞭線-闆-橋-墩一體化計算模型,分析瞭在不同軌溫變化幅度下,橋樑伸縮、墩頂水平位移及列車製動荷載對橋上單元闆式無砟軌道無縫線路溫度跨度限值的影響.研究結果錶明:溫度跨度限值隨軌溫變化幅度的增加而降低;為保證鋼軌彊度、橫嚮壓彎變形及鋼軌與軌道闆相對位移等滿足要求,噹攷慮橋樑伸縮時,以軌溫變化40℃為例,其適應的溫度跨度限值為271 m;隨著墩頂水平位移的增加,橋樑溫度跨度限值顯著降低,噹墩頂位移為30 mm時,溫度跨度為237 m,噹高墩橋樑墩頂位移超過30 mm時,應結閤實際墩頂位移計算溫度跨度限值;製動荷載下線路坡度對溫度跨度限值影響較小,噹線路坡度為20‰時,橋樑溫度跨度限值為258 m.
위연구괄응련속량교상단원판식무사궤도적최대온도과도,채용유한원방법건립료선-판-교-돈일체화계산모형,분석료재불동궤온변화폭도하,교량신축、돈정수평위이급열차제동하재대교상단원판식무사궤도무봉선로온도과도한치적영향.연구결과표명:온도과도한치수궤온변화폭도적증가이강저;위보증강궤강도、횡향압만변형급강궤여궤도판상대위이등만족요구,당고필교량신축시,이궤온변화40℃위례,기괄응적온도과도한치위271 m;수착돈정수평위이적증가,교량온도과도한치현저강저,당돈정위이위30 mm시,온도과도위237 m,당고돈교량돈정위이초과30 mm시,응결합실제돈정위이계산온도과도한치;제동하재하선로파도대온도과도한치영향교소,당선로파도위20‰시,교량온도과도한치위258 m.
To investigate the reasonable limit value of the distance between two fixed bearings of a continuous beam bridge on which unit slab non-ballast track was layed, a rail-slab-bridge-pier integrated model was established by the finite element method. In conditions of different rail temperatures,the influence of bridge temperature change,the lateral displacement at the top of pier, and train braking on the limit value of the distance between two fixed bearings of the continuous beam bridge was analyzed. The results show that the limit value decreases with an increase in the amplitude of rail temperature variation. Taking the rail temperature variation of 40℃ for example,the limit value is 271 m due to the requirements of rail strength,transverse bending deformation,and the relative displacement between rail and slab. With the increase of the lateral displacement at the top of pier,the limit value decreases significantly. When the displacement is 30 mm,the limit value is 237 m. When the displacement is more than 30 mm,the limit value should be calculated in dependence on the actual displacement at the top of pier. In addition,the track gradient has little influence on the limit value under braking load condition:When the track gradient is 20 ‰,the limit value is 258 m.