CAJ | 학술논문

提出了从带钢板形数据中提取典型板形缺陷向量的方法，即先对带钢板形缺陷进行初级分类，再根据带钢应力之间的相似度提取出单位典型板形向量，最后采用k均值聚类算法求解出典型比值系数。针对提取出的带钢单位典型板形向量而设计出的单侧倒角工作辊，经过大规模的轧制试验，所轧宽带钢板形质量较好，综合平坦度均小于5 IU (1 IU=10-5)，基本消除边中复合浪为主的复杂浪形缺陷。
제출료종대강판형수거중제취전형판형결함향량적방법，즉선대대강판형결함진행초급분류，재근거대강응력지간적상사도제취출단위전형판형향량，최후채용k균치취류산법구해출전형비치계수。침대제취출적대강단위전형판형향량이설계출적단측도각공작곤，경과대규모적알제시험，소알관대강판형질량교호，종합평탄도균소우5 IU (1 IU=10-5)，기본소제변중복합랑위주적복잡랑형결함。
This article introduces a method of extracting the typical defect vector of strip shape. In the method, firstly the strip shape defects are primarily classified, then the unit typical strip shape vector is extracted according to similarity among strip stresses, and finally the typical ratio coefficient is solved with the k-means cluster approach. Aiming at the unit typical strip shape vector extrac-ted, a taper work roll was designed and put into a large-scale trial. It is shown that the shape quality of rolled strips is better than before. The comprehensive flatness is below 5 IU, and side and middle composite buckles are basically eliminated.