CAJ | 학술논문

为研究大棚膜下滴灌灌溉上限与施肥量耦合对番茄光合、产量及水分利用效率的影响，以金鹏1号番茄为试材，按照二元二次正交旋转组合设计原理，建立了光合与产量指标的数学模型，分析了水肥两因子的耦合效应。试验结果表明，所建模型达到显著水平；水对光合的影响大于肥，对产量的影响小于肥，水肥对光合和产量的耦合分别存在显著的负效应和正效应；光合速率随灌溉上限的上升表现出明显的上升趋势，超过一定范围后开始下降；不论灌溉上限高低，光合速率均随施肥量的增加表现出先降低后升高的趋势，变化趋势缓慢；番茄的产量随灌溉上限和施肥定额的增加而显著增加，超过一定范围后产量逐渐降低。得出合理的灌溉施肥指标：灌溉下限为田间持水量的50%，灌溉上限为田间持水量的80%～82%，施肥N 313.75～439.75 kg/hm2、P2O5156.55～219.19 kg/hm2、K2O 313.75～439.75 kg/hm2。此时，番茄的产量达到124 t/hm2、水分利用效率达到43.2 kg/m3。
위연구대붕막하적관관개상한여시비량우합대번가광합、산량급수분이용효솔적영향，이금붕1호번가위시재，안조이원이차정교선전조합설계원리，건립료광합여산량지표적수학모형，분석료수비량인자적우합효응。시험결과표명，소건모형체도현저수평；수대광합적영향대우비，대산량적영향소우비，수비대광합화산량적우합분별존재현저적부효응화정효응；광합속솔수관개상한적상승표현출명현적상승추세，초과일정범위후개시하강；불론관개상한고저，광합속솔균수시비량적증가표현출선강저후승고적추세，변화추세완만；번가적산량수관개상한화시비정액적증가이현저증가，초과일정범위후산량축점강저。득출합리적관개시비지표：관개하한위전간지수량적50%，관개상한위전간지수량적80%～82%，시비N 313.75～439.75 kg/hm2、P2O5156.55～219.19 kg/hm2、K2O 313.75～439.75 kg/hm2。차시，번가적산량체도124 t/hm2、수분이용효솔체도43.2 kg/m3。
Studies on how to improve the photosynthesis rate and yield of tomato, which are mostly affected by water and fertilizer, are receiving more and more attention. However, little is known about the coupling effect of irrigation and fertilizer on tomato’s photosynthesis rate, yield and water use efficiency (WUE). Our research was to find the best water-fertilizer coupling effects, to reveal the relations between two, and to provide data support for high yield and WUE for tomato production. Randomized block design through quadratic regression orthogonal rotary method with 16 treatments and three replicates was used in this research. The irrigation lower limit was 50% of field capacity, irrigation maximum and fertilizer were divided into 5 levels (60%, 66%, 80%, 94% and 100% of field capacity; N:P2O5:K2O 125:63:125, 200:100:200, 375:187:375, 550:275:550, 625:313:625 kg/hm2, respectively). Each block was 7 m×1.2 m with 25 plants; blocks were separated by 50 cm deep plastic film to prevent the cross penetration of water and fertilizer. Tomato Jinpeng 1 seedlings with 5 leaves were transplanted with double rows of 60 cm row spacing and 30 cm plant spacing in plastic tunnel on March 9, 2013 and uprooted on June 20, 2013. Ten days after transplanting, 3 fertigation devices (MixRite-2054, Israel) were used for irrigation through mulched drip irrigation. Soil moisture was monitored using TDR (TDR 300, USA). When the moisture was lower than the lower limit, drip irrigation was supplied to the corresponding maximum; the drip velocity and time were measured and recorded. Fertilizer of each treatment except P2O5 was equally supplied for 5 times (before transplanting, the 1st, 2nd, 4th and 6th fruit enlarging period); P2O5 was all supplied as base fertilizer before transplanting. The photosynthesis rate was measured with portable photosynthesis systems (Li-6400, LI-COR Biosciences Company, USA) between 9:00-11:00 am on May 30, 2013. The yield and the quantity of water and fertilizer for each treatment were recorded. By building a mathematical model about its photosynthesis and yield, the coupling of water-fertilizer was analyzed and studied. The results suggested that the two models were significant, and the determination coefficientR2was 0.93 and 0.95, respectively. Photosynthesis rate was more influenced by water than fertilizer, however the yield was opposite. The water-fertilizer coupling and yield were positive related. A significant ascend trend of photosynthesis occurred with the increase of irrigation maximum, and it began to decrease when the irrigation maximum reached a certain amount. Moreover, disregarding the amount of irrigation water, the photosynthesis increased first and then decreased slowly. The yield increased remarkably with an increase in irrigation water and fertilizer of a certain range, but decreased when the quantity was exceeded. Water and fertilizer affected yield and WUE due to their impact on photosynthesis. The yield wasn’t linear correlate with photosynthesis. The medium water and high fertilizer were favorable for tomato photosynthesis, but lower in fruit yield compared with medium water and medium fertilizer. It also demonstrated that optimizing proportion of irrigation maximum and fertilizer was favorable to increase the yield and WUE, which provided water and fertilizer use guideline for high yield and highly efficient production of tomato. The most suitable combination of irrigation and fertilizer was as follows: irrigation lower limit was 50% of field capacity, irrigation maximum was 80%-82% of field capacity, and the fertilizer was 313.75-439.75 kg/hm2 of N, 156.55-219.19 kg/hm2 of P2O5 and 313.75-439.75 kg/hm2 K2O. Under this combination, the highest yield and WUE were 124 t/hm2 and 43.2 kg/m3 water, respectively. Verification test was conducted from 5 August, 2013 to 18 November, 2013 using these rates of fertilizer and water at South Horticultural Field of Northwest A&F University showed a similar result. This indicated that the models were reliable and could provide guidance for agricultural production.